Which is the Best CNC Controller: GRBL or G2Core?

Поділитися
Вставка
  • Опубліковано 23 січ 2025

КОМЕНТАРІ • 7

  • @arbjful
    @arbjful 9 місяців тому +1

    What is the alternative option for GRBL?

  • @JesseSchoch
    @JesseSchoch Рік тому +4

    arduino grbl and g2core are both pretty much abandonware. sorry to say but this video is irrelevant. also, why not mention linuxcnc, grblesp32, grblhal??

  • @Duraltia
    @Duraltia Рік тому +3

    Why even bother making a comparison between the two Firmware when one has such a glaring problem like constantly forgetting its Machine Settings? 🤨
    By the time I'd be needing a 4-6Axis Machine the costs for a proper Controller not running a Firmware pulling such a stunt should be a non-issue! 😑

    • @AdjustinThings
      @AdjustinThings Рік тому +1

      An esp32 alone would multiplex the entire thing over a single wire faster than the arduino can do in parallel. Plus has wifi and bluetooth and is probably actually cheaper too.

  • @AdaptivePhenix
    @AdaptivePhenix 9 місяців тому

    Talking about toys while (mostly) showing _real_ CNCs.
    Open-loop steppers are a joke; here, CNC = Computer Numerically _Commanded_ because they run totally _blind_ . "Controlled" is when you have feedback to verify that the axes are following the commands.

  • @theguy186
    @theguy186 22 дні тому

    if i had a dime evertime i see stuf liek this. in my opinion grbl is a joke too,.. finda filmwere for pcb ploter taht works,.. man,.. joke i tell you, you programers program for what 15 years tiem and dont ahve oen desent pcb grbl ploter set up done,.. i woud be cring,..

  • @Naten609
    @Naten609 11 місяців тому +2

    This video is a joke