I made big powerful 12 pole motor using 32 screws

Поділитися
Вставка
  • Опубліковано 10 лют 2024
  • this DC motor is huge but can do huge things
    playlist I made about how to make DC motors,link below DC motor hacks and experiment: • How to make DC motors
  • Наука та технологія

КОМЕНТАРІ • 6

  • @ghanankoaa966
    @ghanankoaa966 4 місяці тому +2

    😢😢

    • @TechDiy987
      @TechDiy987  4 місяці тому

      Why the tears..

    • @TechDiy987
      @TechDiy987  4 місяці тому +1

      About your question,the other time,the connections are made like this:strip off a part of the starting end of the copper wire and wind it around the first commutator then come down to the rotor and wind the wire around it(depending on the composition you want to take, maybe u want to wind it around two or three slots)the when you are done with the winding on the first pole,u strip off another point where the wire would contact the second commutator and after stripping it off,you wind your coil around the comm.and down to the poles and around the slots in the same direction you did it the first time and then repeat.But after you are done winding,take the striped end of the wire to wind around the first commutator,so after winding,you come back to the first commutator and the you are done,put it between two magnets face north south of each other and put powered to the commutator and it starts spinning 🤗🤗

    • @ghanankoaa966
      @ghanankoaa966 4 місяці тому +2

      @@TechDiy987 Thank you for explaining, I did one some time ago and it rotated 180 degrees, the problem was how the ends of winding are connected to the commutator ..Thanks 🤥🤥🤥

    • @TechDiy987
      @TechDiy987  4 місяці тому

      No problem

    • @TechDiy987
      @TechDiy987  4 місяці тому

      I actually had the same problem when starting but it's all better now😅😅