Gm Silverado Sierra Transmission Mount Replacement 2014+

Поділитися
Вставка
  • Опубліковано 2 лют 2025

КОМЕНТАРІ • 35

  • @jasoncolahan1033
    @jasoncolahan1033 2 роки тому

    Bro…perfect narrating over the work you were doing. Especially the part about the wood!!!! Thanks man!

  • @dateatorjr9671
    @dateatorjr9671 6 років тому +1

    3 years out of a trans mount, wow. And it doesn’t even plow. Thanks for another great video!

    • @AaronHinesAuto
      @AaronHinesAuto  6 років тому +1

      ya no kidding! thanks for the kind words! and thank for watching

  • @kickemassicus
    @kickemassicus 2 роки тому +3

    Great video, no fluff just meat and potatoes

  • @JoseDiaz-qs2op
    @JoseDiaz-qs2op Рік тому +1

    your video really helps, thank you

  • @adewey33
    @adewey33 Рік тому +1

    Thank you. I might as well replace this mount while replacing the driver side engine mount
    My car is 2014 Chevy Suburban LT 1500 2WD Rear

    • @Chrismckinney1
      @Chrismckinney1 Рік тому

      I just did my Tahoe’s engine mount. How did you fair with that job.

  • @jjgaming6772
    @jjgaming6772 3 роки тому +1

    Yo!! Thank you so much I believe this pertains to 2000s and up rwd for this style mount saved my driveline with this worked for a 06 SWB 1500 used a iron plate that was plenty wide enough to lift came right up even re-alligned my exhaust to where it is supposed to be much obliged!

  • @kaptainCream97
    @kaptainCream97 3 роки тому +3

    What was the truck doing before replacing??
    I have a 2014 Sierra 1500 and when I slow down to about 10mph it jerks and it shifts a little hard

    • @squallymold2411
      @squallymold2411 23 дні тому

      Hey man I am 3 years late but my truck is doing the exact thing what did you do to fix it

  • @sergios.delpilar7020
    @sergios.delpilar7020 3 роки тому

    Thank u ...its really informative...keep the good work....God Bless!!!!

  • @darianthompson5975
    @darianthompson5975 7 місяців тому

    Great video

  • @josebarajas2857
    @josebarajas2857 8 місяців тому

    What do you mean the after market part doesn’t work the same?

  • @axgibsonprs27
    @axgibsonprs27 5 років тому +2

    Thank you!

  • @marcus7980
    @marcus7980 8 місяців тому

    What usually causes the trans mount to break? I watched your vid and replaced mine but am wondering if I could have done something to prevent it?

    • @drew5992
      @drew5992 8 місяців тому

      Wear and tear

  • @janc9125
    @janc9125 3 роки тому +1

    Does anyone have the torque spec for the nut that goes through the crossmember? Mine has come loose twice now, I get a squeak each time.

  • @audirx8
    @audirx8 5 років тому +2

    Was there any viabrations caused from the bad mount?
    Shaking on the hwy or anything

    • @AaronHinesAuto
      @AaronHinesAuto  5 років тому +2

      yes high way speeds and upon shifting.

  • @Aquatic_Amigo
    @Aquatic_Amigo 5 років тому

    Is the Gmc 2008 Sierra that same way to change the mount ?

  • @EduardoRamirez-du4tx
    @EduardoRamirez-du4tx 5 років тому

    Hey bro when you're putting on the motor mounts and the transmission one is it better doing it one by one

    • @Dubsspeed
      @Dubsspeed 4 роки тому

      Oh yea one at a time using a jack and block of wood carefully at the minimum!

  • @jaredcorser3372
    @jaredcorser3372 3 роки тому

    Man I have been beating my head trying too figure out why my truck was shacking checked my trans mount it's broke in the front cus my check engine light want on so I was like wtf checked it mines cracked thank u I willing to bet that's my problem

  • @TuneInBurnOutTV
    @TuneInBurnOutTV 5 років тому

    Ho w did you know it was bad? What symptoms? Trans slop a stop and go?

    • @AaronHinesAuto
      @AaronHinesAuto  5 років тому +2

      yes, stop and go slop and heavy thud when downshifting to pass

    • @TuneInBurnOutTV
      @TuneInBurnOutTV 5 років тому

      @@AaronHinesAuto I have been trying to track down a similar issue with my l460e in my 14 4x4 sierra. I have a vodeo kimicing the noise shifting. Usually once its warm its noticeable.

    • @coolasscoleo
      @coolasscoleo 5 років тому

      Mine was a sqeek!!

    • @Cre4ture_official
      @Cre4ture_official 8 місяців тому

      Did you ever find out what it was? Im currently having this issue, 2015 silverado 5.3 4x4 clacking noise when creeping in 1st gear. In rhythm with the idle. @TuneInBurnOutTV

  • @MollyBrown8
    @MollyBrown8 6 років тому +1

    The 2003 Sierra manual transmission does not have enough room to lift.
    The crossmember has to be removed.

    • @AaronHinesAuto
      @AaronHinesAuto  6 років тому +1

      That’s a bummer. this video is for This video is for 2014+

    • @ShawnS.41405
      @ShawnS.41405 5 років тому +1

      Molly you jack up the transmission just enough to get the old transmission mount out and put the new one in and let the jack down

    • @guitarguy3221
      @guitarguy3221 Рік тому

      @@ShawnS.41405 yeah i was thinking you didn't need to remove the xmember on the 99-06.
      I'm gonna use 2 steel plates and washers bc my poly replacement mount broke after 3yrs. My crossmember Is warped around the bolthole

  • @josejuan61
    @josejuan61 4 роки тому

    Yeah ! The ratchet works better ;)

  • @MrInternational716
    @MrInternational716 11 місяців тому

    Thank you!