Very nice greenhouse once put together and seems sturdy. I am a woman and put this together by myself and it WAS an ordeal- if you expect that up front it will help you through it! The instructions were good imo with pictures and well written English but confusing at times causing me to back track. Becareful if you have the 6x6 since these instructions are for the 6x4- many are the same but some are not. But this video is an excellent resource and very helpful. My advice is DON’T skip ahead thinking you got it because you might miss something resulting in removing parts and going back. Really pay attention to number of screws to slide into channels since if you don’t add the right number you will need to go back MANY steps. DON’t throw out the included tools since they are very helpful in tightening the bolts - better than a drill imo. Also that little wrench 🔧 is needed for the main frame since bolts are so close together. It took me a several days to put this together since I took frequent breaks for my sanity:-) and several days were added to reinforce panels using silicone ( I did a few panels at a time then took breaks so not to breathe in fumes even if outside). If your working alone you will need to be creative ( using chairs etc.) to hold up sides or panels since they will fall over until the main frame is together. You will also need a step stool ( unless your 6f tall) for the roof. Remember painters tape is your friend and can serve as a set of hands while screwing pieces together. Get an old blanket or knee pads since you will be on the ground a lot. I put it up inside of a garage which allowed me to take my time. Someone suggested attaching it to the base while building to keep it square and that might have worked better. If you do that you will need to get it up with no breaks since the wind can take it down if it’s not all together. I also secured the perimeter frame to the base with self tapping screws and the posts cemented into the ground. Panels were siliconed in on the outside ( make sure if using silicone area is well ventilated) and allow to it to cure( i used several tubes of GE 12 A) . TIP- they gave me extra screws- but buy extra and add extra to some channels since you can the add wood or molding type strips (by attaching to holes drilled on wood/molding) using these screws to further reinforce panels. Also the top EDGE of the door slides under (with the wheels inside)that bar that holds it in place with the large groove opening in the bar facing out. The bar is held in place by that long screw. Don’t tighten that screw tight since door won’t slide. It took me a long time to figure this out. Hope this helps!
This thing is a nightmare to piece together. The frame does not magically stand upright and not one of the clear panels stays in place. I think I'm going to need to glue them all in.
![How to Assemble Glory™ 8 Series Greenhouse | Canopia [FULL GUIDE]](/img/n.gif)
Very nice greenhouse once put together and seems sturdy. I am a woman and put this together by myself and it WAS an ordeal- if you expect that up front it will help you through it! The instructions were good imo with pictures and well written English but confusing at times causing me to back track. Becareful if you have the 6x6 since these instructions are for the 6x4- many are the same but some are not. But this video is an excellent resource and very helpful.
My advice is DON’T skip ahead thinking you got it because you might miss something resulting in removing parts and going back. Really pay attention to number of screws to slide into channels since if you don’t add the right number you will need to go back MANY steps.
DON’t throw out the included tools since they are very helpful in tightening the bolts - better than a drill imo. Also that little wrench 🔧 is needed for the main frame since bolts are so close together.
It took me a several days to put this together since I took frequent breaks for my sanity:-) and several days were added to reinforce panels using silicone ( I did a few panels at a time then took breaks so not to breathe in fumes even if outside).
If your working alone you will need to be creative ( using chairs etc.) to hold up sides or panels since they will fall over until the main frame is together. You will also need a step stool ( unless your 6f tall) for the roof. Remember painters tape is your friend and can serve as a set of hands while screwing pieces together. Get an old blanket or knee pads since you will be on the ground a lot. I put it up inside of a garage which allowed me to take my time. Someone suggested attaching it to the base while building to keep it square and that might have worked better. If you do that you will need to get it up with no breaks since the wind can take it down if it’s not all together.
I also secured the perimeter frame to the base with self tapping screws and the posts cemented into the ground. Panels were siliconed in on the outside ( make sure if using silicone area is well ventilated) and allow to it to cure( i used several tubes of GE 12 A) . TIP- they gave me extra screws- but buy extra and add extra to some channels since you can the add wood or molding type strips (by attaching to holes drilled on wood/molding) using these screws to further reinforce panels.
Also the top EDGE of the door slides under (with the wheels inside)that bar that holds it in place with the large groove opening in the bar facing out. The bar is held in place by that long screw. Don’t tighten that screw tight since door won’t slide. It took me a long time to figure this out. Hope this helps!
Great video! Thanks for making my job far easier!
Hahaha...this is the one I just got in 6x8. I should be able to assemble it using this video. I will only need to order about 4 chinese assemblers.
This thing is a nightmare to piece together. The frame does not magically stand upright and not one of the clear panels stays in place. I think I'm going to need to glue them all in.
Thank you for the instruction video. It is so helpfull and it is so nice.
Greenhouse doesn't stay upright while being put together
Is this a gosunny? I have a gosunny 6x6 I'm putting together and I'm stuck, lol
It says 4x6 not 6x6
in 10 years this is going to be a wildly popular shitpost
DO NOT BUY!
This is best tutorial on this house not even close directions horrible