Damn, out of the tons of videos I've watched your was the only one that made any sense and thats because you showed your work and how to use the tool VERY WELL DONE you've helped me more than you know thank you!
Great detailed video very helpful, just one note did you set your timing light for 6 degrees as per the manual. I tried at 0 degrees and i was not able to correctly see the F mark. With the light set at 6 degrees it was spot on.
Saveno - No - my timing light doesn't have that - for your trype of light you should set yours to zero and recheck and set - or try another timing light - something is not right
Aiden - you need four basic things for an engine to run. Air to get in, good compression, fuel and spark - so check your air intake and filter, do a compression check, clean carburetors, check ignition cables and replace spark plugs - let me know how you make out - Cheers from Canada!
@@carquestions Do you know why my bike might be leaking white smoke a little bit out of that breather on the top of the engine? Where that tappets and cam are? It's a freshly rebuilt engine bored 50 over only 80 miles on it and I'm not sure if I should be worried about it or not. It's a 75 cb400f
Damn, out of the tons of videos I've watched your was the only one that made any sense and thats because you showed your work and how to use the tool VERY WELL DONE you've helped me more than you know thank you!
Anytime RC - cheers from Canada!
Great detailed video very helpful, just one note did you set your timing light for 6 degrees as per the manual. I tried at 0 degrees and i was not able to correctly see the F mark. With the light set at 6 degrees it was spot on.
Saveno - No - my timing light doesn't have that - for your trype of light you should set yours to zero and recheck and set - or try another timing light - something is not right
Righton man! Great tips!
Anytime Blueman - Cheers!
What should I do if I can't move the plate far enough to get the timing in spec?
something is wrong then - you may have the timing light on the wrong cylinder - triple check your work - Cheers and keep at it Kanes!
Great vid but how do u set the time if the bike won't run
Aiden - you need four basic things for an engine to run. Air to get in, good compression, fuel and spark - so check your air intake and filter, do a compression check, clean carburetors, check ignition cables and replace spark plugs - let me know how you make out - Cheers from Canada!
@@carquestions ok it will run but it takes like an hour to it to crank and it has fuel like it's really hard to actually get it to run
@@carquestions and even then it's hard to get it to idle also just letting you know it's a Honda 250 custom
@@aidenbailey1234 Remove and rebuild the carburetors - will help a lot
@@carquestions ok will do I might do a video
Use JIS screwdriver, NOT Phillips on these old Japanese bikes
Yes SB - should have mentioned that - good advice - Cheers
@@carquestions Do you know why my bike might be leaking white smoke a little bit out of that breather on the top of the engine? Where that tappets and cam are? It's a freshly rebuilt engine bored 50 over only 80 miles on it and I'm not sure if I should be worried about it or not. It's a 75 cb400f