Qu-Bit Aurora custom firmware, spectral / comb filter
Вставка
- Опубліковано 4 жов 2024
- Input is just a sawtooth from Shapeshifter through Ripples low-pass throughout the demo.
0:10 using mix knob to attenuate notches
0:15 using warp knob to offset the notches
0:20 using blur knob to change the number of notches (goes from a notch every other FFT bin to bins the size of the full spectrum so it can be used as a bad lo/hipass)
0:44 adding CV control to the warp/offset (just slow LFO from Maths)
0:58 setting mix to dry, to demonstrate the new input signal (basic ripples low-pass with cutoff modulation)
1:06 turning mix knob to bring back the CV modulated notches
1:12 unplugging the CV control to manually tune the blur/warp
1:26 CV back to warp...
1:38 turning reflect-knob, which is mix control for the Comb Filter / delay (time-knob sets offset of wet signal in samples, 1-16k)
1:50 adding some reverb (from Beads) outside camera
2:06 mixing in nautilus set to fast delay (even more karplus)
2:16 nautilus and beads off, only hearing the Aurora again
2:37 turning atmosphere-knob which is lowpass counter clock-wise, and hipass clock-wise.
3:04 changing input signal frequency from Shapeshifter
Get the prebuilt binary for free: tsarpf.gumroad...
Buy me a coffee: www.buymeacoff...
Source code: github.com/Tsa...