Thanks. I just got one in yard sale. Rusty but cleaning up nice. Just stopped by to check the clocking because of the offset hole. It was wrong when I got it
Well it tells me your airtubes have to be stoped up find a spring that fits the tubing and run it all up on their and into the mixing chamber and blow it out afterwards you may want to boil the burner tube in hot water ...if it's not rusty just anything t I break up the clog and run your spring or heavy wire whatever you can find that works through it while it's fresh and wet good luck brother
Just picked one of these up today, can you give any advice on how to remove the part that you where pumping, I couldn’t get it to build up pressure so I’m hoping the washer is just toast
Pop off clip then pump should just pull straight out you may try dropping some 2 in 1 oil down into I it should be a hole on silver piece I hope this helped ...use flat screwdriver and small plates t I remove clip easily
Thanks. I just got one in yard sale. Rusty but cleaning up nice. Just stopped by to check the clocking because of the offset hole. It was wrong when I got it
Thank you brother man I hope I could help ya
I have a 220j that has fuel coming out of the generator but not getting to the mantles? Any suggestions?
Well it tells me your airtubes have to be stoped up find a spring that fits the tubing and run it all up on their and into the mixing chamber and blow it out afterwards you may want to boil the burner tube in hot water ...if it's not rusty just anything t I break up the clog and run your spring or heavy wire whatever you can find that works through it while it's fresh and wet good luck brother
@@darrellbigdaddydcarter9224 Thanks will try that tonight.
@@davidelks8972 your more than welcome good luck
Just picked one of these up today, can you give any advice on how to remove the part that you where pumping, I couldn’t get it to build up pressure so I’m hoping the washer is just toast
Pop off clip then pump should just pull straight out you may try dropping some 2 in 1 oil down into I it should be a hole on silver piece I hope this helped ...use flat screwdriver and small plates t I remove clip easily
Bout to rebuild 2 220j's. I'm nervous. I don't wanna mess em up!
No fear brother once you start it will come easy
New subscriber here. Cool lanterns
Hey brother I appreciate you and thank ya were just chill in the shop and I'm glad to have ya on bord brother
well done sir