I have a Powermax 105 that keeps misfiring. What is the problem and how do I fix it? I have a water separator by the air compressor and a double water separator just before the plasma cutter air inlet. I have lots of air going to it and it never drops below 100 psi when I depress the gun trigger. I have replaced all the consumable parts on the gun with new parts and it still keeps on misfiring. I have a powermax 30, 45, and 2 105's and i have also tried swapping wipes from the other plasma cutters and no change. Any information would be very grateful!!
Except my powermax 45 has been getting intermittent pressure failures since like 6mo of ownership, and I got either 1 or 2 pressure sensors under warranty, and they seem to help for a bit but then it goes right back to it a while later. Mostly while static, test mode or not, and it flicks back and forth. It'll work fine for a few minutes, then won't work for an hour. Sometimes it'll work for several hours with no flipping to fault, etc. Pretty random. I'm pretty done with it causing me to miss ship dates and bought a $300 Amazon one as a backup. I really wish this d*** thing was reliable because I really like it!
MBarton, so sorry for the delay in seeing this comment from you. Have you contacted our technical support team to help diagnose any further issues? you can reach out to them here : www.hypertherm.com/en-US/contact-us/?category=GeneralFeedbackQuestions&form=technical-questions
@@hypertherm I have, several years ago, and was told that I was out of warranty now, and I'd have to start paying for the parts they wanted to keep throwing at it.
I have a Powermax 105 that keeps misfiring. What is the problem and how do I fix it?
I have a water separator by the air compressor and a double water separator just before the plasma cutter air inlet.
I have lots of air going to it and it never drops below 100 psi when I depress the gun trigger.
I have replaced all the consumable parts on the gun with new parts and it still keeps on misfiring.
I have a powermax 30, 45, and 2 105's and i have also tried swapping wipes from the other plasma cutters and no change.
Any information would be very grateful!!
Except my powermax 45 has been getting intermittent pressure failures since like 6mo of ownership, and I got either 1 or 2 pressure sensors under warranty, and they seem to help for a bit but then it goes right back to it a while later. Mostly while static, test mode or not, and it flicks back and forth. It'll work fine for a few minutes, then won't work for an hour. Sometimes it'll work for several hours with no flipping to fault, etc. Pretty random. I'm pretty done with it causing me to miss ship dates and bought a $300 Amazon one as a backup. I really wish this d*** thing was reliable because I really like it!
MBarton, so sorry for the delay in seeing this comment from you. Have you contacted our technical support team to help diagnose any further issues? you can reach out to them here : www.hypertherm.com/en-US/contact-us/?category=GeneralFeedbackQuestions&form=technical-questions
@@hypertherm I have, several years ago, and was told that I was out of warranty now, and I'd have to start paying for the parts they wanted to keep throwing at it.
🇺🇸🇺🇸🇺🇸👍🇺🇸🇺🇸🇺🇸👍👍👍👍🇺🇸👍