Jeep Wrangler GraBars Grab Handle Front Black Pair 2007-2018 Installation
Вставка
- Опубліковано 29 вер 2024
- Freddy shows you how to install this Pair of GraBars Black Front Grab Handles in your 2007-2018 Jeep Wrangler.
Product Link:
www.cjponyparts...
These grab handles are designed to fit 2-door and 4-door Jeep Wranglers and will complete both the front driver and passenger sides. They are manufactured in the USA with 3/4" solid steel and feature a durable powder coat finish. Don't worry about any drilling or dismantling for installation as these grab handles simply bolt directly into existing holes in your Jeeps A-pillar!
Check out more Wrangler Grab Handle parts from CJ's here:
www.cjponyparts...
Check out more GraBars parts from CJ's here:
www.cjponyparts...
Subscribe to CJ Off-Road on UA-cam here:
/ @cjbroncof150
So if your tool or bolt was to get behind the trim how do you remove the trim 😢😂 asking for me 😵💫😵💫😵💫
Not easy if the hole do not line up properly! Two hours in on the first one and I had to abort. What a joke! Tried top first, no luck, then bottom first, no luck. Screws go in easily by themselves but will not align with the handle.
Because of your well worded video/description of the install of this product, I purchased these handles for the pre-owned Jeep I bought. Also, they’ve totally made it easier for my Dad-in-law to get into, & out of the Jeep when my wife & I take him on rode trips! Thanks👍🏾
Video looks simple. In reality, a 45 minute job for me.
I'm not an engineer, but why the FUCK wouldn't the manufacturer of any "off-road" vehicle not have driver and passenger side grab handles installed from the factory?
To make more money asshole.
my installation wasn't that easy. when I removed the top bolt something moved and the threads don't line up with the hole
I took out my bolt that I thought got cross thread and redid it using the other bolt. I also used a better ratchet. And I alternated when I tightened them. They’re totally secure👍
I’ve been under V8s that were just running on 110 degree days for close to an hour and nothing had been as painful and terribly engendered as these grab handles
DO NOT torque these to 25 ft lbs. I have an electronic snap on torque wrench, so accuracy was not the issue. Striped the holes clean out!
Here is a tip unscrew the side one till loose but not all the way. Then use a flexible claw grabber to finish job.
I found it easier to start the top bolt first. Thanks for the tutorial.
I can’t seem to get the top one to tighten anymore and it still has room to go. Did I maybe accidentally cross thread the bolt? If so, what should I do?
TNT. One or 2 sticks should do
❤Great Video. Straight to the point. Well done.👍
WD-40 us not a lubricant. It is a water displacer.
Where does the short bolt go ?
Soooooo how do i remove the frame? 🤦🏻♂️ dropped the spacer. DOH!
Hey Tim - did you ever figure this out? I did the same thing.
I dropped a spacer in the plastic pillar? Is it easy to get to without big job?
I literally just did that rn. 😂
Did you end up getting it out?
Me too!
@@lakrb0y how did you remove that plastic frame? That Phillips-head screw in the other hole wont even come out