Trane VOYAGER Test Mode
Вставка
- Опубліковано 29 кві 2020
- Troubleshooting Trane AC using test mode,
Beginners and pros how to use test function on Trane RTU ac units, to turn on every function without using the thermostat or it’s terminal block
#tranehvac #d2dnyac
If you have wires connected to 1-14 you cannot jump at the conventional terminals. ( R G Y W C ) it set higher priority to the 5vdc circuit
Ooh 👍 thanks for stopping by
🤙
Do NAVAC hoses have some sort of check valve in the hose, as there is no shut-off or does it not need it as it is not a manifold gauge.
No check valve here, and this is an actual gauge and manifold! This gauge and manifold was geared towards mini splits being that they only have one service port.
@@D2DNYAC Yeah, I guess I think manifold has more than one gauge, you are correct. Does it not need shut-off down at end of hose, Montreal Protocol?
I put a jumper between Test 1 and Test 2 It worked ok, and I did it again and the Electronic Board Turned off, I can't see the leds flashings, I had to disconnect and comect the electrical supply and then the board turned on. What happened here? Thanks
If you are using the screw terminals they may be corroded so it's a hit or a miss best to go behind! And if not then the unit may have a control short on either economizer, HEATING or cooling circuit, so I would do it test again and pay close attention to what stage or mode of test the led goes out ie fan, economizer, HEATING cooling etc
What model of Navac gauges are those?
i will let you know
Put the door on over the compressors when reading pressures!
Sure that’s the correct way to do it
I got circuit 1 compressor do not started
help
Got to give me more information than that! If u need me to help
Find a professional
What's reliatel?
Tranes control board inside its smaller RTUs that's capable of using standard non trane thermostats