Thank you, yes, I understand. I will take your warning into account. I cannot leave the camera on a fixed place. It is shaking and I had to wind it quickly because it was a very long work.
Why do you not dial indicate prior to starting any cutting , with it wobbling like it is it puts unneeded stress and ware on the cutters don't you think.
Are you sure that you understand this profession? Man, why shouldn't he go? The tooth went in one go. I am going to the diameter measurement on the tooth with metric diamonds with a sweet gap. There are other videos in which I screwed the flange. Watch them.
You are thinking wrong. If there is runout in this part, you can neither screw it on the ROD nor the cylinder inside the sleeve will work properly. We are processing within ISO9001 tolerances. There is a five percent runout tolerance in terms of diameter and width.
👏👏👏
👍👍
bon travail
Thanks
Güzel işçilik 🧿
Teşekkürler 👍
Çok güzel bir işcilik
Teşekkürler
I love watching watch makers at work .
enjoy watching👍👍
Great vide but shaking the camera ( aka fast forwarding the editing ) made for a difficult video to watch .
Thank you, yes, I understand. I will take your warning into account. I cannot leave the camera on a fixed place. It is shaking and I had to wind it quickly because it was a very long work.
Informative work
thanks
молодец, качественно делаешь коллега👍
thank you colleague👍
Why do you not dial indicate prior to starting any cutting , with it wobbling like it is it puts unneeded stress and ware on the cutters don't you think.
I couldn't understand what the sign was. Are you talking about catharsis?
Nice work
Thanks 👍
@@MyLatheWorld welcome
👍
👍🏻👍🏻
Контроль резьбы осуществляется по штангелю. Вряд ли эта гайка куда-то навернется)
Are you sure that you understand this profession? Man, why shouldn't he go? The tooth went in one go. I am going to the diameter measurement on the tooth with metric diamonds with a sweet gap. There are other videos in which I screwed the flange. Watch them.
Сразу видно интернет эксперта.
👍👍
What thread pitch were you trying to achieve?
I pulled 4 teeth
👏👏👏👏👏👏
👍👍
Very good work from UK
Thanks
👍👍👍👍
👍👍
👍👍
👍👍
I think I’m getting motion sickness 😵💫
👍👍
what lathe is this????
SMTCL
@@MyLatheWorld рулеточный станок
@vladimirfed2060 👍
😨😱😱😱
👍👍
Se tivesse centrado melhor a peça bruta , teria torneado os diâmetros dando menos passes .
Man you could have dialled that material in closer than that!
👍👍👍
No kidding. Easier on the machine and tooling
you have long wait to go for the lathe
👍👍
Terrible camera control
👍
Não vi na de mais.
👍👍
感覺流程不好，內徑這樣加工同心度有誤差
You are thinking wrong. If there is runout in this part, you can neither screw it on the ROD nor the cylinder inside the sleeve will work properly. We are processing within ISO9001 tolerances. There is a five percent runout tolerance in terms of diameter and width.
Esos platos para centrar es una perdida de tiempo,
Yes, you are right, but this material came crooked.
Please quit shaking the camera .
👍