Honda NC750X OEM Light bar installation

Поділитися
Вставка
  • Опубліковано 25 жов 2024

КОМЕНТАРІ • 10

  • @mikemayberry3553
    @mikemayberry3553 6 років тому +4

    Thanks for the video, I have a new 2018 750x and have the black bars, but I cannot seem to fit the bars under the light, cannot get the nut between the two plates to bolt it down at the two points shown from underneath, any tips would be helpful.

  • @neiltroman6851
    @neiltroman6851 Рік тому

    I did not use the bolts supplied under the headlight. I found it impossible to fit. Cut some longer bolts down to make a stud. Put nuts into the frame first and screw the two studs into the two nuts. I used lock nuts. Nyloks. This then gives you two hanging studs two offer the frame up to. Then put on another lock nut to hold the frame inplace. Its fiddly to get a spanner inplace but easier than trying to locate the nuts bolts spanners and frame at the same time. Note. t=The studs can be longer than the original supplied bolts.

  • @luiscoelho3523
    @luiscoelho3523 2 роки тому

    Since they are called "light bars" are they supposed to protect the bike a little bit? Or just a fragile light hanger? :)

  • @riderfiles8606
    @riderfiles8606 4 роки тому

    Thank you for posting. Did you notice any new vibration sounds after installing?

  • @p.santos6644
    @p.santos6644 5 років тому +1

    Nice video, thank you for sharing 👍👍👍

  • @sunuk1915
    @sunuk1915 3 роки тому

    Nice job 👏👏👏👏

  • @yosuquintana6576
    @yosuquintana6576 5 років тому +1

    Good video, but i cannot fit the left side to screw, cause a part of the bar, crash to the top of engine.

  • @muratevdeyok5448
    @muratevdeyok5448 Рік тому

    how can I buy? where is it sold?

  • @acpgiga
    @acpgiga 6 років тому +1

    As crash bars, are they any good?

    • @Checkpat
      @Checkpat 5 років тому

      They seem to be so near the side of the NC750... think that the fall of the bike even during stop will brake the side of the bike