Stomp demon x xlr140 throttle problems

Поділитися
Вставка
  • Опубліковано 19 січ 2025

КОМЕНТАРІ • 31

  • @gavinmcvey8177
    @gavinmcvey8177 4 роки тому +5

    Use a sponge air filter mess ones mess up the a,f mixture 🇬🇧still bogin change your carb altogether mate bigger is sometimes better on a yx engine they have a big valve head and update your cdi coil before touching the valves mate I've learned that mistake before😎🇬🇧because you could make things worse rather than better😎

    • @connorjack3246
      @connorjack3246 2 роки тому

      Inlet 0.10 & outlet 0.15 are they the best clearences?

  • @Bikebros27
    @Bikebros27 Рік тому

    I’ve got issues with a stomp 110c will work fine for about 30mins then. Will keep stalling and bog down under full throttle and can’t figure out why.

  • @H.1d0t
    @H.1d0t 2 роки тому +1

    I have a stomp 140 the bike isn’t running right is a pain to start ther bike has a massive loss of power will bog most of the turn when full throttle anyone know what my problem is

  • @JamjarMcg
    @JamjarMcg 6 місяців тому

    State of that air filter a panicky after its been a few rides that's horrid that's a old filter on a new engine why can't get past this!

  • @paulstir
    @paulstir Рік тому

    can you show this carb tare down i need to see the plate and spring config

  • @jakeowensacousticartist4812
    @jakeowensacousticartist4812 3 роки тому

    Did you have to put a fuel tap on ? Just bought one and it does not have a fuel tap ? So the over fill was pissing fuel after I had been driving for 3 hours, think it may need a carb clean but also a fuel tap would help

  • @nevemckdo1591
    @nevemckdo1591 5 років тому +2

    Did you solve problem when you do hard gas it cut down

    • @leecleeton2881
      @leecleeton2881  5 років тому

      Hi, yes, I ended up putting a new carb on as the carb slider was worn

    • @fourdouble6
      @fourdouble6 4 роки тому +1

      Lee Cleeton hello mate I have a demon x 140 and it’s bogging when i Rev it and it will cut off as well it idles fine but really boggy and misfiring and just losing power so should I get a new carb?

    • @leecleeton2881
      @leecleeton2881  4 роки тому

      @@fourdouble6 Hi mate, the slider in your carb is worn, the only answer is to replace. Solved my problem 👍

    • @fourdouble6
      @fourdouble6 4 роки тому

      Lee Cleeton thanks 👍🏼

    • @fourdouble6
      @fourdouble6 4 роки тому

      @@leecleeton2881 hello Mate I changed my carburettor to a mikuni and I fitted it the bog is still there I have also changed the spark plug im not sure what the issue is but it's nothing to do with the carb

  • @harrybailey3591
    @harrybailey3591 4 роки тому

    So I have a stomp z3 140 and I recently got a new can’t it’s a mikuni one. I’ve installed it and when I started the bike it was revving very high. I am aware you have to put the carb back together properly as it will hold the throttle wide open 😂 but I think this is a different problem ?

    • @harrybailey3591
      @harrybailey3591 4 роки тому

      Any ideas what it may be

    • @bbb8775
      @bbb8775 3 роки тому +1

      idle screw on carb

    • @ruriijassem7252
      @ruriijassem7252 2 роки тому

      @@bbb8775 bro i need your help basically my bike wont start i fixed everything it in it it smokes but just wont turn on I assume its calibrator issue but cant solve it any idea it feels like its getting too much of something = air or something I am not sure

  • @ttid7298
    @ttid7298 2 роки тому

    Hi mate got exact same bike molkt carb think it needs replacing did you change yours to mikuni or stick with molkt, the carb keeps leaking fuel whenever the taps on if you can save me the money please help

    • @leecleeton2881
      @leecleeton2881  2 роки тому

      Hi mate, You have 2 different problems going on, the fuel leaking is due to the float sticking, if you give the carb a good clean with carb cleaner and put it all back together that will fix that, however if you have the bogging down problem also i would just stick a molkt carb on it, it will be cheaper and also already set up from the factory. but if you are a regular user then i would pay the extra for the milkuni. but spend the time to clean it 1st, it could be a float problem and it is over fuelling.

    • @ttid7298
      @ttid7298 2 роки тому

      @@leecleeton2881 thanks for the help bud 👍🏽 know anywhere I can get a mikuni carb as everywhere I've found is international or stomp has one but sold out lol hoping to get my girl racing in a month got some work to do and need to learn the ins and outs of my bike rode almost my whole life but know fuck all about em🤦🏽‍♂️

  • @ahamflett6733
    @ahamflett6733 3 роки тому

    i have a bike but it dont let me throttle it can run if i put it in gear but i use the kill switch anyone know

  • @danieljackson4821
    @danieljackson4821 Рік тому

    What exhuast have you got on this ?

  • @franco6293
    @franco6293 2 роки тому

    Mine is having problems with peak power

  • @erasmusmack2443
    @erasmusmack2443 3 роки тому

    Full filter is upside down

  • @Kkenno91
    @Kkenno91 4 роки тому

    To lean 👍