Excellent service lesson. I have done my umbrella orient before. If you have a next gen control and PAID for parameter access is is about the same procedure?
It’s actually a little easier on NGC basically once you have the dogs lined up to the umbrella pocket you’ll do a S (for spindle) and I believe F2 to set the orientation
Hello, I have a remote control the same (mpg) do you know if I just have to connect it and it works or I have to move some parameters I appreciate your helpfulness regards
MY friend accidentally sent the double arms into the dogs today after I replaced the TRP; will this action have any reaction? Ill reorient the spindle in the morning thanks.
what if my spindle never orients? it just keeps spinning. I've checked the 4077 and 4031 parameters and they're set. m19 just makes the spindle start spinning.
Dear Sir,our machine have problem spindle orientasi,when we check used M19 spindle turn left and right ( we info card spindle servo must be adjust). Can you please support for it's.
This is also necessary if your drilling and alarm on high Z thrust.
Hey great instructions! Can you do a video on how to open up the Umbrella Style Tool Carasoulle for cleaning?
It's a HAAS VF2
There’s a pin on the back side u can take off to open the sliding door of the umbrella to clean inside the platter
Excellent service lesson. I have done my umbrella orient before. If you have a next gen control and PAID for parameter access is is about the same procedure?
It’s actually a little easier on NGC basically once you have the dogs lined up to the umbrella pocket you’ll do a S (for spindle) and I believe F2 to set the orientation
Hello, I have a remote control the same (mpg) do you know if I just have to connect it and it works or I have to move some parameters I appreciate your helpfulness regards
MY friend accidentally sent the double arms into the dogs today after I replaced the TRP; will this action have any reaction? Ill reorient the spindle in the morning thanks.
No, it should be just fine.
Great 👍
what if my spindle never orients? it just keeps spinning. I've checked the 4077 and 4031 parameters and they're set. m19 just makes the spindle start spinning.
Dear Sir,our machine have problem spindle orientasi,when we check used M19 spindle turn left and right ( we info card spindle servo must be adjust).
Can you please support for it's.