Athena YZ144 Kit - Big Bore Case Mods and Top End Install. Project YZ144 part 6
Вставка
- Опубліковано 28 гру 2022
- Here I modify my 125 cases for the 144 cylinder / piston, clean up the power valves and get the engine back in the bike.
- Навчання та стиль
Thanks for the heads up.
We ordered one today should be here tomorrow so we will see
Do you think I could install a newer yz big bore kit (2005-2021) to a 1996 yz 125
Do you know if the process is the same for the 85 to 112 kit?
Do you absoloutely have to do this??? I've been seeing a lot od videos of what seems like people not doing this, just putting the piston on and cylinder. ???
On the Athena website it specifically says “This cylinder kit can be installed without making any changes to the engine crankcase.” I don’t know exactly why he cut that thing up😅
Don’t listen to me I would 100 percent do this. after reading more closely you are required to. My mistake
any issue of filling it with silicone instead of tape and playdo, once its dry just rip the whole lot out
Sounds like that would work but I have not tried it. Basically anything that will seal it up and then come back out without leaving a mess or working its way into the crank/bearings will do the trick.
What is the ring end gap supposed to be, I also put a big bore on my 125 but I think I made the gap way to big because it burns engine oil like crazy
My man twocstowks don’t have engine oil on top end
You most likely have bad crank seals
Is it worth it??
Will it work if I return 125cc on moded 144cc case
Yes it will, no issues switching back and forth if you need to.
You didn't com up with shavings because aluminum isn't magnetic bud lol.
LOL is right! Not sure what I was thinking there, good catch!
144= blowout. pistons are very limited