More videos to follow... Link Pin Shim Setup, Spindle Installation, Link Pin Adjusting, Dropped Spindle Tie Rods Explained and many more! So make sure to subscribe 🤓 Thanks!
@@TheMrProbasco Ha, ha, yeah, I hear you. It takes a lot of tools to do it properly. Plus, that's what I do for a living, so not looking to give out that info for free 👌
Hey Rob, Absolutely! Same procedure to measure offset, no matter what spindle you're using. Any other questions, just let me know. Thanks for watching!
More videos to follow... Link Pin Shim Setup, Spindle Installation, Link Pin Adjusting, Dropped Spindle Tie Rods Explained and many more! So make sure to subscribe 🤓 Thanks!
Also... Let me know what videos you'd like to see or any questions you may have! Enjoy!
How to rebuild a king pin would be SUPER helpful in like...a couple days when my box gets here.
@@TheMrProbasco Ha, ha, yeah, I hear you. It takes a lot of tools to do it properly. Plus, that's what I do for a living, so not looking to give out that info for free 👌
What if I narrowed a stock beam and one sides a 7 and one’s a 5? 😢
Sounds like you fucked up🤪
Does this apply to stock?
Hey Rob, Absolutely! Same procedure to measure offset, no matter what spindle you're using. Any other questions, just let me know. Thanks for watching!
I used a big square. Mine measured dead on 7mm.
Man, they never come out to 7mm for me, ha, ha.
Wide Five because mines stock. Ha ha!!!
@@conrad1468 Thumbs Down, Booo!
Wide Five ha ha!!
Will this method work to set up my 1976 super beetle decklid shims?
Yes😜
Wtf? I've been payin good $$ for this info. Now you're just giving it away Cletus?
😂😂😂😜