I'm not sure what I did wrong, but I was getting "cannot extrude curved face" when trying to complete the final step. My frustum is reversed from yours (large diameter on top), but otherwise is similar. I have no idea if something you did along the way was different, however, because there was no voice narration. It's also unclear if the geometry you created with the line tool needed to be created in that order of 2 shapes, or if it could have been created with 1 line and still achieved the final result.
Luke, I think that one of the vertices of the trapezoid you need to rotate is not in the blue-red plane. It can be tricky to use only endpoints that are in the red-blue plane.
Saudações do Brasil, procurei muito como fazer isso e não encontrava. Me ajudou muito, obrigado❤
thank you for this video, you have saved me a lot of time
You're welcome.
Ty for this video.....it helps me a lot
I'm not sure what I did wrong, but I was getting "cannot extrude curved face" when trying to complete the final step. My frustum is reversed from yours (large diameter on top), but otherwise is similar. I have no idea if something you did along the way was different, however, because there was no voice narration. It's also unclear if the geometry you created with the line tool needed to be created in that order of 2 shapes, or if it could have been created with 1 line and still achieved the final result.
Luke - I will try to get a new video out by tomorrow, with an audio track.
Luke, I think that one of the vertices of the trapezoid you need to rotate is not in the blue-red plane. It can be tricky to use only endpoints that are in the red-blue plane.
Thank you so much. works!
That helps a lot - especially when making an oblique solid.
Thankss, BR thank you
Trank you
Muito obrigado
Thanks
Such a waste of time.