Would you mind adding the pieces or parts that you used to build it, and putting them on the video description... you did an amazing job... however I would like more guidance on those parts. Thank you
i like that electrical tape band- aid---I was hoping to see how u got the assembly out of the body... the local dealer said to remove the wheel and wheel well to access the mounts... He said it was a tedious job to remove the whole assembly..
I've never went through the wheel well to remove the light. the nuts are one the front wide of the frame so I pull the bumper off. it takes about 10 minutes to do but there's 3 10mm nuts holding each headlight onto the frame.
How do you get the actual headlights out of the car? I've been looking around and I can't seem to find any information on it. I'm honestly about to just start dissembling the front end until they come out.
+Bradley Hockensmith I had this plastic tab pop out. it's currently loose inside. I was adjustable the the height of cut off and I heard something fall loose in the housing. now the whole projector is loose. what should I do? pop it open an put the tab back in?
+MrMerk1991 That's what happened to mine, just disassemble the housing like this. you'll fine the other piece and just need to connect them back together. Mine had actually broken and needed replacing.
Would you mind adding the pieces or parts that you used to build it, and putting them on the video description... you did an amazing job... however I would like more guidance on those parts. Thank you
i like that electrical tape band- aid---I was hoping to see how u got the assembly out of the body... the local dealer said to remove the wheel and wheel well to access the mounts... He said it was a tedious job to remove the whole assembly..
I've never went through the wheel well to remove the light. the nuts are one the front wide of the frame so I pull the bumper off. it takes about 10 minutes to do but there's 3 10mm nuts holding each headlight onto the frame.
Do the plastic piece go right back on it
How did you get the headlight secured to the housing frame?
Headlights look very nice! Where did you get them from?
They were a custom retrofit using parts from Theretrofitsource.com
They also had lots of fiberglassing for the eyelid and the ring that surrounded the light.
What size are the after market lenses you installed 7" ?
How do you get the actual headlights out of the car? I've been looking around and I can't seem to find any information on it. I'm honestly about to just start dissembling the front end until they come out.
I had to take the grill and front bumper off of mine in order to unscrew three pins just to take the headlight out. it's was a pain in the ass
How did you warm it up?
how did you get that whole headlight plastic housing assembly out? mine is cracked
ah haaaa OK,, the vehicle is not here right now, but If I pull the bumper off, its easy to get the whole light body out.. OK,, thanks for the tip.
How do you take the assembly out of the vehicle...?
Where did you get the halos I'm looking
your headlight alignment tab is broken you said? how did you fix it? just pop it back in or??
I bought a second pair of headlights, split them open, pulled the adjusters out and put them in my customized setup.
+Bradley Hockensmith I had this plastic tab pop out. it's currently loose inside. I was adjustable the the height of cut off and I heard something fall loose in the housing. now the whole projector is loose. what should I do? pop it open an put the tab back in?
+MrMerk1991 That's what happened to mine, just disassemble the housing like this. you'll fine the other piece and just need to connect them back together. Mine had actually broken and needed replacing.
+Bradley Hockensmith ok got ya. mine looks like I over adjusted and it popped out. thanks for the help an fast response, appreciate it!
How match $?
Does this work for any jeep patriot year?
This seems janky