ProtectGuard WF Premium. Wet Look Sealer Installation.

PRODUCT DESCRIPTION
ProtectGuard® WF Premium gives porous and low-porosity mineral surfaces an intense "wet effect"; in other words, it restores and revives the original colour of surfaces. ProtectGuard® WF Premium is traffic resistant and produces the wet effect for a long time.
ProtectGuard® WF Premium also provides a protection against water, oil and stains. It also provides long-term protection for materials and prevents the principal causes of deterioration such as atmospheric pollution, dirt and grease. It slows down the ageing of the support and makes it easier to maintain.
ProtectGuard® WF Premium is an impregnation product, the
support can still let through air and water vapour
ADVANTAGES AND CHARACTERISTICS
• Produces a wet effect that really revives the colour.
• New technology: lasts for 3 times longer.
• Limits penetration by water and dirt.
• Improves resistance against freezing and thawing.
• Lets the support breathe.
• Can be reapplied without removing everything.
• Economical: very good return
• Low COV and eco-solvent.
• Ready to use
HOW TO USE
Preparation of support:
• Apply the product to a clean, dry surface free of dust and grease (moisture content less than 5% by mass).
• Use Guard Remover® Eco Efflorescence & Cement 50% diluted to prepare the surface before treatment.
• If there are grease stains, use Guard Cleaner® Eco Soiled Floors. If there are traces of efflorescence, laitance or veils on cement, use pure Guard Remover® Eco Efflorescence & Cement.
• Rinse thoroughly until the surface is free from any trace of cleaning product.
Application:
• Shake the package thoroughly before use and use the pure product: do not dilute or mix with another product.
• Carry out a preliminary test on a small area. STEP 1: APPLY
• Apply in one thin layer without excess. It is not necessary to soak the tool with the product, just a small amount of product is enough.
• Do not overload the support; all of the product must penetrate the surface.
STEP 2: WIPE
• After 10 minutes, the treated material must be wiped off and polished with a lint-free microfibre cloth.
• On large surfaces, apply by steps to avoid walking on the product when wiping
• Where necessary, apply a further layer to homogenize the wet effect.
• Drying protected: 24 hours.
• Optimal efficiency reached after 7 days.
Check out our full range - www.guardindustry.com.au/shop/​
Guard Industry home - www.guardindustry.com.au/