How to Adjust Headlights on 2013-2018 Nissan Altima

Поділитися
Вставка
  • Опубліковано 1 лют 2025

КОМЕНТАРІ • 15

  • @claytondales3011
    @claytondales3011 15 днів тому

    Thanks for this video!

  • @MarieJBay
    @MarieJBay Місяць тому

    Thank you !

  • @CubanVJ
    @CubanVJ Місяць тому

    Legit. Thanks for the instructions.

  • @adamsgrizzly01
    @adamsgrizzly01 Місяць тому

    Thanks for the info buddy

  • @Autistic-Uhbuddy
    @Autistic-Uhbuddy 23 дні тому

    Is there any way to aim them not just by the height in other words can I straighten them out if they are off to the left or to the right too much?

    • @KennyRamDashCam
      @KennyRamDashCam  23 дні тому

      Not that I'm aware off. You could try putting spacers or washers behind between the bracket and the frame where they screw in

  • @khaliqking7142
    @khaliqking7142 Місяць тому +1

    Are the adjustments needed only up and down Or is left and right needed as well? I just switched out my bulbs yestarday and my passenger beam is pointed to the right and illuminates the curb as I drive. The drivers beam I cant even see but I think its point to the right as well.

    • @KennyRamDashCam
      @KennyRamDashCam  Місяць тому

      Up and down only. The projector lights have a cut off on them. The cutoff point of each light is lower on the left than the right, so that may be what you are seeing and not a bad left to right alignment. Double check that none of the light brackets are broken

  • @boodiddy2006
    @boodiddy2006 29 днів тому

    I have brand new headlights and discovered they are pointed down, I'm going to use a socket to adjust them, have any suggestions of how many turns it may take?

    • @KennyRamDashCam
      @KennyRamDashCam  28 днів тому

      I don't. The further down they are the more turns it'll take to get them to the correct level

  • @Sauceguy241
    @Sauceguy241 2 місяці тому

    I'll have to try this, turning that screw wasn't working for me either

    • @KennyRamDashCam
      @KennyRamDashCam  2 місяці тому

      you have to have the correct size screwdriver for the screw. Best to use a wrench or socket