Water Methanol for the 2022+ Subaru Wrx | New Project | Snow Performance Custom Setup | BMS Tank

Started a new project for the 2023 Wrx. Adding water methanol to cleanse my intake valves, throttle body, map sensor and intake manifold all while adding a layer of knock suppression and cooling.
I built a custom kit using a Snow Performance 300psi pump, Burger Motorsports 2 gallon tank with pump mount, Snow Performance Vc30 controller and all custom made in house wire harnesses and -4AN hoses to complete the job. Stay tuned.

[@dlfrestoration]

Ok i saw your new here so has to watch for the algorithm. i know how hard it is to gain subs im also chasing my first 1k . Hopefully you go from strength tk strength 💪

[@pauletecelebradocusi3555]

lol I thought about titanium or aluminum engine bag caps then rethought it when thinking how will I ever remove them when hot

[@Subi_doo]

@@pauletecelebradocusi3555 wish I would have thought about that too lol…. Atleast it only cost me $60 but still can’t use it for the reason I bought it. It has easier to read level markings. Should of been made from delrin or some type of glass infused plastic

[@Subi_doo]

@@pauletecelebradocusi3555 I didn’t do engine cap because I’ve had to many that expand when hot making them super tight and almost impossible to get off when hot.

[@bolei418]

I'm planning to do something similar: intercooler water spray. could you please kindly share how you successfully wired the pipes/tubes through the firewall into the engine bay?
thanks! 🥰

[@Subi_doo]

@@bolei418 foot well by driver side, you will see 2 grommets. 1 is used for the hood release and the other is blank. Pop it out, remove driver side liner wheel liner and you’ll see where it comes out. Then feed it up and through fender into engine bay over strut tower.