OMC 800 outdrive low profile parts

Need OMC outdrive repair and parts see: www.sterndrive.... or contact tech support at T.C. Electronics/Marine [phone]
Video help with the following repair items:
800 Series OMC upper gear case parts
Bearing carrier and bearing retainers
Ball gear shims seal and spring
Gear set 21-18 gear ratio and ball gear set
Install help with the sea kit
Installing water pump on shaft and more
Ball gear plastic shim sizes for the bearing retainer

[@tomsawyer247]

Good video thanks for showing it.

[@alexvaro8326]

Hi Wayne, could you do a video on how to remove the entire upper unit from the intermediate housing. I need to specifically know to remove and route the shift cable out of the intermediate housing. I can not find a video here on UA-cam on how it’s done. Thanks

[@jmburk55]

It looks like there can be good information here. However, the camera is zoomed in way to close which makes this video useless.

[@tommybradley8423]

So I have a right hand drive set up. I just replaced the cable...my question is what does that gear connect to and where..? Is it somewhere on top of the lid

[@tomsawyer247]

At 27:05 there are some water pump shims in the upper left of the screen that weren't mentioned could you tell me if they are needed.

[@mikeriley8546]

grest video.wish i could contact you guys.still trying something up with phone restrictions on your end.

[@jamesballenger3991]

Hi Wayne, I found the model number and serial on the plate on the side but I can't find anywhere that tells me what the actual unit I have, model #981059 serial #W96595

[@oaklandraidersfootball9256]

Constent Knocking noise stern drive all modes neutral, forward or reverse no shift problems? Knocking noise speeds up with rpms no vibrations 😬 what part in the stern drive can cause Knocking noise with it being gears and bearings? Knocking doesn't change with load 🤔🤔

[@oaklandraidersfootball9256]

Note No knocking noise from engine with drive detached from engine omc stern 5.7

[@byronk1987]

Did you find out your problem? Water pump shaft wore out, or the electronic shift cable not working?

[@19787626]

Hi. Any one her how can tell me a website ther i can get help to find a lower gear cabel for a older omc stringer 800.
Best reguards Tomas

[@samuelsegovia9219]

195 galaxia gurepon holgasques