Nice, that should pull you out of basically anything. We had to use the 300 to pull the 650 brute out of a hole. the 650 was sitting on the frame and wedged into the side bank. up to the rack on the deep side. we had to anchor the 300 to a tree otherwise it would just slide forward. but it pulled the 650 out with very little difficulty. the 2000lb winch was working hard but didn't power out and didn't require a snatch block for dual line pull.
No issues so far. I always make sure to run lots of low pressure water through the rad while cleaning the machine after rides. this has been a larger issue with the 650 but carries over to the 300. always make sure the rad is clear.
Going to try the same with a BadLand 2500. 2022 BF 300 so your video was very helpful at figuring out the mounting and the wiring! Appreciate it!
Nice, that should pull you out of basically anything. We had to use the 300 to pull the 650 brute out of a hole. the 650 was sitting on the frame and wedged into the side bank. up to the rack on the deep side. we had to anchor the 300 to a tree otherwise it would just slide forward. but it pulled the 650 out with very little difficulty. the 2000lb winch was working hard but didn't power out and didn't require a snatch block for dual line pull.
Thank you
Really helped me out. Thanks!
Awesome, glad I could help!
Where did you wire in the little red wire? Did you go into an ignition wire and if so what Color? Thanks
Ever had any over heating problems with the BF300?
No issues so far. I always make sure to run lots of low pressure water through the rad while cleaning the machine after rides. this has been a larger issue with the 650 but carries over to the 300. always make sure the rad is clear.