Anyone trying to remove the front bumper, the top comes off first on top of the headlight. Pull up and toward you but more upwards. The bottom below the headlight is the same but make sure you take care to let the lower part slide off its hinge at the corner. These front bumpers have a lot of plastic welds so be careful especially if they are older than 5 years. The plastic is pretty brittle
My t20 bolts in the door handles won’t tighten what do you suggest doing ? I can’t get the small back piece to tighten when I put the door handle together
I know this is an older video, how did you get the front door panel actually off after pulling the trim, I removed all the fasteners and its not obvious which way to pull or lift it off the door frame, and the bottom section seemed very locked to the door, I took out the two door edge philips, and the 3 5mm hex bolts from the middle and still not able to move the door off the frame. Not sure if I am not pulling it the right direction. I figured up and out would do it but nope. Only difference on my 18 Ti AWD is the extra HK speaker grille.
I don't remember the location of the fasteners but once those were all out, I used an upholstery pry tool and went around the perimeter of the door card to pop all the snap pins, then once those were loose, I gently wiggled the door card upward to free it from the window lip.
Unfortunately, I didn't remove those so I'm not sure. I would think they're just attached with regular snap pins, so would just be a matter of carefully prying it up with an upholstery tool.
@@MechannibalGarage65 Thanks for your answer. In the video, it seems that the door panels only have screws, but no clips. Is that right or are there clips on the bottom of the door panels?
I'll ask the car owner, but it's easy to get the headlight lens off, either a heat gun or bake in an oven at low temp. It's the same procedure for most cars.
Why did you not show the procedure to remove the rear bumper? You showed the front bumper removal and then you stood by the rear bumper and the next thing I saw was the bumper was completely off the car. I really needed to see the procedure for rear bumper removal because some idiot decided they would push one of my parking sensors in with their finger and there is no way to get to it and pull it back out unless you pull the bumper off the car. Now I have to go to the dealership and to have the bumper removed, the sensor replaced, and the bumper reattached, I know I'm going to be spending about 750 bucks.
Anyone trying to remove the front bumper, the top comes off first on top of the headlight. Pull up and toward you but more upwards. The bottom below the headlight is the same but make sure you take care to let the lower part slide off its hinge at the corner. These front bumpers have a lot of plastic welds so be careful especially if they are older than 5 years. The plastic is pretty brittle
When these cars come down in value, this video is going to be wildly popular with the DIY'er crowd. Thanks!
Nice beautiful video thanks for the help
Thanks a lot man... I have this car and I need to remove the front bumper for the same wrapping purposes. This video is awesome 👍💪🙏
Excellent guide, Thank you!
Awesome Video, show us a video when it's completed!
love the wrapping color
My t20 bolts in the door handles won’t tighten what do you suggest doing ? I can’t get the small back piece to tighten when I put the door handle together
Nice video, but i was wondering about the headliner. I want to wrap my roof without the sharkfin but not sure on how or where to start
...for the quattro formaggio? Didn't you mean for the quattro stagioni?
Looks soooo good!
I know this is an older video, how did you get the front door panel actually off after pulling the trim, I removed all the fasteners and its not obvious which way to pull or lift it off the door frame, and the bottom section seemed very locked to the door, I took out the two door edge philips, and the 3 5mm hex bolts from the middle and still not able to move the door off the frame. Not sure if I am not pulling it the right direction. I figured up and out would do it but nope. Only difference on my 18 Ti AWD is the extra HK speaker grille.
I don't remember the location of the fasteners but once those were all out, I used an upholstery pry tool and went around the perimeter of the door card to pop all the snap pins, then once those were loose, I gently wiggled the door card upward to free it from the window lip.
Great video! Can you also explain how to remove the outer B pillar trim? Is that difficult?
Unfortunately, I didn't remove those so I'm not sure. I would think they're just attached with regular snap pins, so would just be a matter of carefully prying it up with an upholstery tool.
@@MechannibalGarage65 Thanks for your answer. In the video, it seems that the door panels only have screws, but no clips. Is that right or are there clips on the bottom of the door panels?
I want to do a chrome delete inside the headlights in the Giulia, is it possible for you to make a video of this? Thank you!
I'll ask the car owner, but it's easy to get the headlight lens off, either a heat gun or bake in an oven at low temp. It's the same procedure for most cars.
Are you sure you can’t remove the front window belt mold without taking the door card and mirror off?
I don't think so, or at least I wasn't able to figure it out
Why did you not show the procedure to remove the rear bumper? You showed the front bumper removal and then you stood by the rear bumper and the next thing I saw was the bumper was completely off the car. I really needed to see the procedure for rear bumper removal because some idiot decided they would push one of my parking sensors in with their finger and there is no way to get to it and pull it back out unless you pull the bumper off the car. Now I have to go to the dealership and to have the bumper removed, the sensor replaced, and the bumper reattached, I know I'm going to be spending about 750 bucks.
I forgot to film it... But it's actually easier than the front.