Motion Sensor Light without Arduino | PIR sensor

[@avishrangari4401]

If you could please tell about which resistors are used

[@RoboCircuits]

2.2k and 10k

[@AnkurTipsAndTricks]

​@@RoboCircuitspicture may to 100 ohm aur 1k likha hkya sae h please tell. I have to make it

[@terrificbutcool2884]

Which bulb was used here?

[@ICTS_Gunathilaka]

can we use use vibration sensor like this?

[@RoboCircuits]

Yes

[@anandjoshi8554]

@@RoboCircuits but one need a off delay timer circuit with pir and ir sensor , as they frustrated by triggering output relay unnecessary

[@x-6790]

can u make a nrf transmitter and receiver for drone

[@RoboCircuits]

Yes
Will try and let you know

[@AyeAye-q3e]

Relay 1 Channel Relay only?
Other 5pin Relay Use?

[@anandjoshi8554]

but one need a off delay timer circuit with pir and ir sensor , as they frustrated by triggering output relay unnecessary

[@RoboCircuits]

Yes … there is sensitivity and delay adjustment in the sensor itself

[@anandjoshi8554]

@@RoboCircuits yes there are > but if someone not give a movement inside room within the time value set < PIR output goes Off> same with IR sensor...flickering trigger, as hands many times goes out of range of IR front ..>> we need a backup source to continue getting ON signal/supply to avoid interruption in output load.( i am trying some circuits presently)

[@RoboCircuits]

@anandjoshi8554 thats true… in these cases we use micro wave sensors or presence sensors. But there the cost increases drastically

[@VijayJosephm]

If you could provide links to buy the components, it would greatly help.

[@RoboCircuits]

Yes

[@remiarmy4369]

Yes we also need the price of components

[@industron22]

Contact me for readymade pir switch

[@avilazarus5406]

power supply of 5V nd how many ampere?

[@RoboCircuits]

0.6 Amp

[@PankajKumar-gr3qm]

Great video 👍👍👍

[@RoboCircuits]

Thank you☺️☺️☺️

[@ramanchauhan2282]

Awesome video sir🤗🤗🤗

[@RoboCircuits]

Thank you very much.
Your support is very much appropriated

[@akshay_hr06]

Yes bro

[@mianushjawale]

Bro components link please

[@RoboCircuits]

Will update as soon as possible

[@EnglishVocabularyWithMnemonics]

Good piece of work.

[@RoboCircuits]

Thank you! Cheers!

[@flyingrobots4937]

I will definitely build one

[@RoboCircuits]

Sure

[@haloxsmart]

great stuff

[@RoboCircuits]

Thank you