torque the screws after you do the shake test, look on the plug itself and it should tell you the specs then take them to that amount and then you are good to go. the amount of wire showing on the leads is a tad too much, just trim them down a bit to be on the safe side. keep on learning and DIY.
I miss the wasp clip
torque the screws after you do the shake test, look on the plug itself and it should tell you the specs then take them to that amount and then you are good to go. the amount of wire showing on the leads is a tad too much, just trim them down a bit to be on the safe side. keep on learning and DIY.
❤