Hold the part upright in the mill vise between two vee blocks - one against a stop. Find the center and cut all 4 sides in one setup with the side of the cutter all using the same offset. It will save the corners of your endmill & get a much better finish.
Nice little money maker. For speed I probably would have used a 4 sided 5c collet block instead of a dividing head, but that's me. Nice job!
I dont have one of those . Its the second time i have heard that though. So many wants so little room
@@Wrighmachining Okay gotcha.
Was going to suggest the same. Plus a hex collet usefull too
Hold the part upright in the mill vise between two vee blocks - one against a stop. Find the center and cut all 4 sides in one setup with the side of the cutter all using the same offset. It will save the corners of your endmill & get a much better finish.
Good prospective . Thanks
Do you have a video that's opposite were you take rough cut square 1in by 1in 9 in longstock and make it round on a mill?
I do not sorry
Good work.
Thank you Ben!
👍👍👍
👊