Jäger rifle scratch build pt 37 installing the patchbox spring

#jäger #rifle #build
in this video you will see the installation of the spring for the sliding wooden patchbox.
so thanks for watching and dont forget to like and subscribe

[@richardparker4590]

Patchbox lid spring install went well, thanks for sharing.

[@homemadehistory7537]

and the next video is in progress.... some engraving and gold inlay😁

[@453421abcdefg12345]

That worked out well Roger! A bit cold in the workshop today, plenty of filing needed to keep warm. Stay safe! Chris B.

[@homemadehistory7537]

oh it is freezing cold here... 🥶minus 10°C now it is time to make some engraving

[@homemadehistory7537]

and some smal gold inlay 😆 stay safe and kind regards Roger S-

[@olibertosoto5470]

Got to remember these chisel and file sequences are at warp speed. Sometimes I forget and "yikes, that chisel is out of control! - or that file is taking too much!" But it never does. 👍🏼

[@homemadehistory7537]

I need to ad a digital speed control to the chisels 😆🤣🤣and a screen that shows the moves per minute 😆

[@allanrichards3752]

Will that catch not feel awkward against your shoulder when shooting?

[@jomoma8576]

It's on the side of the butt that doesn't really touch your shoulder & it's small & fairly flat basically don't even feel it if you're wearing a shirt

[@homemadehistory7537]

You dont feel it... there is a lot of flesh on the shoulder😁

[@jachse8464]

Why not thin down the spring and grind off part of "bend"? The spring strength is personal preference, but the bend will dig into the shoulder when shooting.

[@homemadehistory7537]

For the last one I made the sping out of one block, that was way more easy.... maybe on a later point I will make a new sping that sits more close to the butplate. That will make a more lower profile posible 😁

[@jachse8464]

The amount of parts you make from scratch is pretty amazing. I think I finally caught back up, so I am looking forward to the next build.