Wood-Mizer Sawmill Blade Guide broken? Here's the fix! Diagnose and repair
Вставка
- Опубліковано 7 вер 2024
- Learn the process of fixing a broken sawmill. In this video, I go about the process of diagnosing and repairing a broken blade guide on the sawmill. Is it the motor? The wiring? The electrical system? The switch? Find out and see if I can play a good mechanic yet again.
Good trouble shooting. Good to see you again.
God bless you too,
Lee
I’m glad to see you doing well, and the sawmill running fine
Great video. Good troubleshooting and repair. 👍
It’s been a while since I seen a video from you. Of course I was out of commission for a little over 3 weeks with COVID PNEUMONIA. Love watching your videos.
Hope that you will get a full recovery.
@@jdelbrid thanks. It’s a slow process but trusting in the good lord for complete recovery.
3 months ?
So happy to see a video from you. I wait for one every day. Hows the new shed workin for you?
God bless you and your family.
Sawmill shed is great! We've been a bit busy lately, so not a lot of time to record and edit anything.
I have an issue tonight with my lt40SH. I went to change blade, i loosen the tenison to 0. Tool old blade off and the wheel wouldnt slide over so the new blade would go on correct. Usually i just put the idle side wheel over and put new blade on. I hit it w rubber mallet and block of wood. Its locked up. Wont budge. I made sure the tension handle was out about 2 inches thread showing. Still locked as if the tension hadnt been released. What you think?