HOW TO CHANGE THE BRAKES ON A NISSAN X-TRAIL (ROGUE) | DIY
Вставка
- Опубліковано 1 гру 2020
- Learn to easily change the brakes on your car! Here I work on the rear of my Nissan X-Trail (Rogue) which is a little more tricky than other vehicles I have done, so hopefully watching this will make your job a breeze!
If you have any suggestions or questions, please put them in the comments below, and if you enjoyed this video please consider giving it a like and subscribing to the channel!
Follow:
/ chrisdoesstuffza
/ chrisdoesstuffza
www.chrisdoesstuff.co.za
Disclaimer:
This channel and all of its videos are intended for entertainment purposes only. I work in a manner in which I feel safe based on my experience and surroundings. This may not be the same for you.
Should you attempt to do any project based on the instructions given in this video it is at your own risk. I take no responsibility or liability for any injury or loss as a result of this video.
Remember, power tools and electricity can be dangerous. Always follow the manufacturers recommendations and warning labels. Always use the correct PPE, avoid loose clothing and make sure that long hair is tied up out of the way of any rotating part.
Remember, you are responsible for your own safety! Don't be doff. - Навчання та стиль
Best video for doing this that I have found. The caliper retraction cost me hours and your trick got the job done. Also, I took the whole assembly apart but in hindsight, I could have not done this as you show in your video. Great video thanks for posting.
Thanks man, I also struggled plenty! I figured that I just needed to share, because those details aren't covered in the maintenance manual.
Nice one. Thank you.
Absolutely spot on! Followed your video to the letter and completed the job, handbrake self adjusts when you apply after fitting the pads so don't worry. I managed to pick up the 3 pin wind back tool which made it easier, fyi, it's the same as the Volkswagen / Audi 3 pin tool. Thanks again!!!
Brilliant, good to know! Ya, if I knew about the wind back tool in advance I would have got one, but by the time I worked it out the breaks were already stripped off.
Thanks again buddy. Saved me a lot of time and money 💰
Bisogna svitare con chiave torx T30 attuatore elettrico togliendo spinetta alimentazione. Poi con chiave torx T45 avvitate in senso orario inserendo chiave nella sede del attuatore fino in fondo, così il pistoncino entrerà senza dover avvitare ma solo spingendolo all'Interno.
What size sockets and spanners are you using
Flip, I will have to check. I suspect it was a 12 or 14, but I don't remember off hand.
kudos for attemping this - i did a bit more digging around the electronic parking brake system, and learned the turning motion of the piston is required to unwind the drive thread that applies trust which works in tandem with the hydraulic pressure to drive the piston. ua-cam.com/video/46KgDEyD0Pc/v-deo.html hope this gives a bit more information around your work flow.
p.s. you are clamping down on the electronic parking brake motor assembly on the back side of the piston - hope nothing broke!
That's pretty interesting, makes a lot of sense. I don't think anything broke, the entire assembly in the Nissan seems to be in the caliper so its well protected.