1979 Camaro | LS Swap | Part 6- Cooling System, Brake Switch, Cleaning Up The Engine Bay
Вставка
- Опубліковано 30 вер 2024
- In this video I finish the cooling system, I hook up the brake switch, I order wrong parts from Amazon, and I clean up and "finish" the engine bay. Hope these videos have been helpful!
LIKE.SUBSCRIBE.COMMENT
Facebook- Krusty Classics Garage
Instagram- KrustyCuda
Are you sure those caps don't have the c clips that hold the joint caps centered in the yoke?
Also someone could have changed that yoke out for a 1350 u joint. I would measure the yoke to confirm which it is.
No. Those u joints and pinions are specific to using those clips that hold the u joint cap in place
@@krustyclassicsgarage i hasn't finished the video when I commented.
Do you have a video on the OBD2 port setup? That’s pretty slick the way it’s routed to the bay. Great work bro 💪🏽
Still can’t believe you did that swap so quickly, would probably take me 6 months, learning a lot so I appreciate it!
You might be able to get ujoint with 2 diferent size end caps I did that a while back for a bel air
How much does a swap like that cost from start to finish?
My bad commented before you found the problem
You can get a 1310/1330 u joint if that is what you mean about a conversion u joint. You might even be able to find it a local 4wd shop.
Yes and no. It needs to be a u joint that uses the old school c clips for 2 caps and newer style clips that hold the u joint into the driveshaft. I'll explain it in the next video when I have the conversion u joint I ordered
You have the wrong u- joint. You can get one that has the retaining clips on the inside at the bottom of the cap. Just a suggestion from an old head.
The u joint came with the driveshaft. I ordered a conversion u joint that had the clip style caps on one side and the newer on the other, but I also re ordered a pinion yoke that I know will resolve the whole issue.
Sounds great
Yes I’m in Houston area and it’s pretty cool
Your shaft looks good man. Like the fact it’s a big white shaft for sure. Tired of seeing those big black shafts.
That's what she said 😛
Haha I was fishing for that comment!
Watch out for them Black Trouser Snakes too 🐍
That’s awesome your letting your wife keep it
I mean, technically its hers as she bought the car and she's bought 99% of the parts used on it lol
fun series man. you crushing it.
Getting a little closer 👍👍
Hobo freight has a box of body shims pretty cheap
I ordered a whole hardware kit for the front end that comes with everything needed to bolt the fenders on
Awesome man! You’re doing it better than most then.