2005-2010 Honda Odyssey Throttle Body Cleaning

Turn on the annotations! Throttle body cleaner: amzn.to/2EMyHBH

[@MrRangerZr1]

Throttle body cleaner: amzn.to/2EMyHBH
Throttle body relearn video: ua-cam.com/video/d35_0-S_84g/v-deo.html

[@axjohn]

Nice video! QUESTION: at 3:13 how did you get the butterfly to open up, did you push something? Or does it open up halfway when you have the weight on the accelerator with the key in the appropriate location (engine not on). Thanks!
I have a 2006 Ridgeline with 137k miles and I’m sure the throttle body has never been cleaned.

[@MrRangerZr1]

@@axjohn you can open the plate pressing the gas pedal down with ignition on

[@feliciamarte3031]

Unbelievable stuff thank u kindly for allll these videos I'm a female who pretty much knew nothing about car and mechanics pretty much keep trying to take my money and constantly lie to me about my car until I started learning with these God given videos God bless these videos and the ones who keep making them❤️🌈❤️

[@oisbuddy]

Very well done. This is the best method for cleaning. Some ppl move the butterfly without turning to accessory mode, which I know screws with the car’s electrical system. Awesome upload.

[@Senorchoo]

Super clean engine bay 👍🏽

[@paulsantos2148]

Thanks. I will try this tomorrow. Hopefully my vehicle will normalize. Thanks again.

[@MrRangerZr1]

+Dave Santiago I know its too late for you but i edited the video finally lol

[@paulsantos2148]

Thanks. I will do this procedure together with the MAF cleaning as well. Have a great weekend.

[@MrRangerZr1]

Hope everything goes well! Thanks

[@jameskim62]

Paul, No problem after cleaning ??? No engine check light or engine hutting up and down ?????

[@paulsantos2148]

I just realized this just now. I disconnected the wiring/plug that is directly on top of the trottle body. Did i screw up and damaged my trottle body? In your video you only disconnect the MAF.

[@georged1085]

Ever heard of a very rough idle almost stall when in drive but fine in every other gear? And goes down road fine

[@amasoak47]

I'd recommend cleaning both MAF sensor and Throttle Body when replacing air filter. Use proper cleaning agents, not wd-40. You will feel the difference on acceleration and idling.

[@pdog2448]

Where did you see WD-40?

[@roberthudson5999]

@@pdog2448 He is just mentioning it as a general recommendation as there is lots of bad advice out there.

[@donjohn924]

Hi just wondering when you put the brick on gas pedal, is the engine running or just electricals on?

[@MrRangerZr1]

No just electrics (ACC) on

[@MTMXBL]

great vid, is it worth taking the throttle body out to clean as per service manual suggestion? I assume with the throttle body out you still should not force open the butterfly valve with your hands?

[@MrRangerZr1]

You shouldn't push the tb plate at all. If you get a new tb gasket, you can take it off and clean it. Up to you.

[@MrBigcat1993]

How did you kept the throttle butterfly open?

[@carlosibarra6189]

Did you watch the video?

[@MrRangerZr1]

I show it in the video lol

[@joecox9958]

how can you keep such car like new? thanks

[@MrRangerZr1]

Just regular cleaning. I don't wait till it gets super dirty.

[@paulsantos2148]

Thanks. I will try this tomorrow. Hopefully it will normalize.

[@MrRangerZr1]

+Dave Santiago Hey are you on the odyclub forum?

[@HT-dp6tw]

Great video. Thanks

[@igl9273]

At 1:15 what is the name of the part you were removing? I got scared to remove it. It is metal.

[@MrRangerZr1]

PCV tube

[@igl9273]

@@MrRangerZr1 Thank you. So, it is okay to remove it. Other cars normally use flexible rubber, right?

[@paulsantos2148]

Have you ever tried cleaning out your EGR system (valve, ports, intake manifold) for carbon build-up?

[@MrRangerZr1]

+Dave Santiago No not yet.

[@paulsantos2148]

MrRanger, did you get a check engine light when you did this procedure?

[@MrRangerZr1]

Yeah i did. Just clear the code or disconnect the battery, my CEL never came back

[@thur-ogi8898]

I let somebody press the gas pedal steady while the engine is on, is it the throttle supposed to be halfway open? Because mine is not. Thanks

[@MrRangerZr1]

No not with the engine on, just turn the key to the run position, do not start it.

[@jameskim62]

I cleaned the throttle body fully opened and closed plus air mass flow sensor. Now engine check light is on with high idle/ 1000rpm and RPM is hutting (up 2000rpm and down 1000). checked for vacuum leaks and disconnected the battery overnight/just negative post, still same. any solutions ?????? last night I have discounted all battery posts and restart the car soon....

[@MrRangerZr1]

Here's your fix: ua-cam.com/video/d35_0-S_84g/v-deo.html

[@jameskim62]

@@MrRangerZr1 Did Manually. Thank U always. Can you do the reset with new Bluedriver OBD2 ??? ua-cam.com/video/-izuZvjCh4Q/v-deo.html

[@MrRangerZr1]

No. Wish it did.

[@CataleyaRose]

Do you have to start the engine and spray with that cleaner?

[@MrRangerZr1]

No just accessories mode watch the video

[@paulsantos2148]

MrRangerZr1, i cleaned the trottle body and runs ok. However when i am in park, the rpm stays at 1100rpm. What could be causing this? Will disconnecting the battery solve this? Help!

[@tonysky7221]

Is true 👍

[@alabrie]

Thanks for the great video. Quick question - what is the component you're reconnecting at 5:00?

[@MrRangerZr1]

PCV line

[@lottreewhite7687]

Nice video .....but after I clean my throttle the check engine and another light come ....then l removed the battery after a few days pass by I get the check engine and the vehicle has no power that on a odyssey 2011
What may cause the problem....Iam so disappointed

[@MrRangerZr1]

dereck marie what codes and what lights. You probably have to do throttle relearn.

[@lottreewhite7687]

What is throttle relearn..,..and how to do it ....is there any video

[@MrRangerZr1]

It's in the description of this video.

[@vladimirolujic6637]

Holy... Did you take this car apart and cleaned every single part individually and then put everything back??? How can it be so clean?

[@MrRangerZr1]

Nah my engine bays are clean like that lol

[@sanctealphonse4510]

stop being shy and narrate already!
LOL

[@allenherinckx4474]

At least he didn't play shit music over the demo.

[@jayquinty]

I replaced an 02 sensor same time I cleaned the TB. Now I have a high idle problem. 1500+ rpm all the time and a P0507 and P2279. Can't find anything on this problem on 2007 EXL. Any ideas? Any chance it's the O2 sensor? I'm going to swap back to the old one tomorrow just to eliminate that possibility.

[@MrRangerZr1]

No you just need to do this: ua-cam.com/video/d35_0-S_84g/v-deo.html

[@jayquinty]

Thanks for responding so quickly. I ordered the scanner and reset it once it arrives. Really appreciate your help.

[@MrRangerZr1]

@@jayquinty its a very good scanner for diy. You can do everything with it like ecu reset tb reset etc

[@paulsantos2148]

Thanks for replying. After doing this procedure, what changes did you notice with your vehicle?

[@MrRangerZr1]

+Dave Santiago I noticed better throttle response and smoother idle. If you have the tools, it worth doing. The cleaner cost around $5-6 at the auto stores.

[@paulsantos2148]

I do go to ody club and browse around with the forums.

[@ChongLevi]

I did the same processes as you demonstrate with my Honda fit..and I have done the idling relearn and travelled around 120miles...However, the engine rpm is fluctuating between 1k to 1.5k rpm (around every 10s) when it is idling at P and N gear... Also, the car is jerking and rpm is fluctuating when moving slow ... Luckily the car is still running smoothly at high speed...
Do I accidentally damage the electronics? Or I didn't clean the throttle body throughly? Hopefully someone can give me an idea... Thanks

[@MrRangerZr1]

Give it more time to adjust. It can takes 2-3 weeks.

[@shawnshighaltitudemedia4507]

Great video thanks. I came across your video after I cleaned my throttle body. something went wrong because now my car wants to accelerate when I put it in drive. I removed the whole throttle body and disconnected the MAP. could I have ruined the map with the cleaner. could you tell me where I might find the steps for the throttle relearn process. Thanks kindly for any help.

[@MrRangerZr1]

+SHAWNS High Altitude Media Ouch, its highly recommended by mechanics NOT to remove the throttle body to clean it. Try to disconnect the battery for 10 mins, reconnect, and before starting the car, engage the hand brake, turn off the AC, and let it idle for 5-10 minutes. Then shut it off and start it again and see if it solves the problem. If it doesn't, then let me know.

[@joseantonetty4117]

+MrRangerZr1 i need you to help me out plz text me at 347-309-7979... thank you...

[@archdenoe9577]

Where the MAP sensor is located on odyssey

[@MrRangerZr1]

Here: ua-cam.com/video/S3w9275quWE/v-deo.html

[@paulsantos2148]

Why are you not talking for this video tutorial? Please advice. Thank you

[@MrRangerZr1]

+Dave Santiago Hey I never got the chance to edit the video. Usually i put annotations and write instructions in the description box.

[@mybestsmile19]

Wow thanks you !!

[@paulsantos2148]

Thanks. I will do this procedure together with the MAF cleaning as well. Have a great weekend.

[@paulsantos2148]

I just realized this just now. I disconnected the wiring/plug that is directly on top of the trottle body. Did i screw up and damaged my trottle body? In your video you only disconnect the MAF.

[@MrRangerZr1]

+Dave Santiago Oh no! Thats why the idle is fluctuating! Just hope disconnecting the battery will fix it....or else you have to perform the idle relearn procedure.

[@paulsantos2148]

I will see today how the car behaves. If nothing happens, i will bring it to the dealer and let them take a look at it. I hope they dont charge me an arm and a leg. Oh well i have been doing maintenance work to my car anyway, I will let them earn a bit from me. 😬

[@paulsantos2148]

MrRangerZr1, i cleaned the trottle body and runs ok. However when i am in park, the rpm stays at 1100rpm. What could be causing this? Will disconnecting the battery solve this? Help!

[@MrRangerZr1]

+Dave Santiago Does it jump from like 800 - 1100rpm? Disconnect the battery for 10 minutes and let it idle for a few minutes after reconnecting the battery ( you can do just the negative terminal ) after few drive cycles it should be normal again.