[NEW] Simple Electronics Project

Поділитися
Вставка
  • Опубліковано 26 вер 2022
  • In this video, I will make the Simple Relay Polarity Remover circuit
    Check the electronic components you need here: www.utsource.net?source=UA-cam
    Utsource is a professional electronic components supplier.
    More than 800 original brands, More than 6 million original products
    Subscribe It's Free ❤️ / @creativecreator
    Needed Components Link About Relay Polarity Remover:
    12V Relay: www.utsource.net/itm/p/158133...
    LED: www.utsource.net/itm/p/115357...
    1N4007 Diode: www.utsource.net/itm/p/112003...
    Resistor: www.utsource.net/itm/p/647851...
    DC Gear Motor: www.utsource.net/itm/p/113041...
    Dot PCB: www.utsource.net/itm/p/120852...
    Potentiometer: www.utsource.net/itm/p/116615...
    Visit my Website for Simple LED Chaser Circuits:
    circuitbest.com/music-reactiv...
    Instructables: bit.ly/ccinstructables
    Follow Me On Social Sites:
    Facebook: / creativeideas365
    Instagram: / creativeideas365
    Twitter: / creativeidea365
    Thanks For Watching
    ✅LIKE
    ✅SHARE
    ✅ COMMENTS
    ✅ SUBSCRIBE
    I hope this video was Useful and you liked it if you did press the thumbs up button.
    Cheers!
    Creative Creator
    :)
    #Electronics #Circuit #Projects
  • Наука та технологія

КОМЕНТАРІ • 66

  • @Creativecreator
    @Creativecreator  Рік тому +2

    I hope you will like it :)
    Schematics: bit.ly/3DVCjDC

  • @prabhash1975
    @prabhash1975 Рік тому +2

    Very useful for reverse polarity protection. Only issue is when the relay become off, cannot desable relay backfire current. (Goes through LED)

  • @douffinguessan1129
    @douffinguessan1129 Рік тому

    C'est Vraiment merveilleux et il peut donner des grands projets j'adore beaucoup merci..

  • @user-qr1cf2qv9g
    @user-qr1cf2qv9g 8 місяців тому

    Its a helpful project, I like it.

  • @SC.243k
    @SC.243k Рік тому +1

    Very good job , creative for sure 👏👏👏👏👏👏👏

  • @Reciclandoideiasoficial
    @Reciclandoideiasoficial Рік тому +2

    Legal seu projeto . Parabéns , também tenho vários projetos assim aqui que eu fiz

  • @mridulnath2468
    @mridulnath2468 Рік тому

    Very important and useful project 👍👍👍

  • @pramodmutha9996
    @pramodmutha9996 Рік тому +2

    Share link of vice you use for 12 v dc motor

  • @biraggodinho7635
    @biraggodinho7635 Рік тому +1

    qual a dificuldade de desenhar o circuito eletrônico 'diagrama esquemático' em um papel e mostra?

  • @limweifah621
    @limweifah621 Рік тому

    Possible to make a video on how to connect an indicator light to 12v radiator fan, which indicate the actual condition the radiator fan is working or not, but not only indicate the power from the relay alone.

  • @leopoldofernandezjr.508
    @leopoldofernandezjr.508 Рік тому +1

    This is Polarity circuit protection 👍.
    In the link helow if im not mistaken. I've read it "polarity remover" 🤔🤔
    Thanks

  • @BrescoLtd
    @BrescoLtd Рік тому

    looking for circuit 2 channels to work inverse to each other for 12 VDC light dimmer. For use on peppers ghost illusion

  • @tubankota8962
    @tubankota8962 9 місяців тому

    Bsa gac untuk ces aki mobil ,relei itu mmpu ap gac seandanya untuk ces aki mobil

  • @anilmohite5281
    @anilmohite5281 Місяць тому

    Congratulations to you good job works yaar 🌹

  • @simpliciocamirino2271
    @simpliciocamirino2271 Рік тому

    thank you for that sharing

  • @JoseCruz-zr7ew
    @JoseCruz-zr7ew 7 місяців тому

    Excelente profe tengo una pregunta de cuantos whatt tiene que ser el resistor esque cuando compro resistencia en el almacen me preguntan y de cuantos whatt y yo no allo que desir por eso le pregunto a usted grasias feliz dia

  • @singingzone3056
    @singingzone3056 Рік тому +2

    Please u make a 220V,500watt AC chaser light circuit with speed controller for coming diwali without PCB by using relay,BT-136 triac,resistor,capacitor etc...
    Please...plz....plz....plz...plz...plz..plz..
    Thanks very much..
    Love from jharkhand❤🤝

  • @mrowl3511
    @mrowl3511 Рік тому

    hi there,how do you use camera

  • @valtersouzaribeiro761
    @valtersouzaribeiro761 Рік тому +1

    Boa tarde parabens muito bom

  • @rabahharb2649
    @rabahharb2649 7 місяців тому +2

    Wrong diagram , the relay is drawing inverse (NO / NC)

  • @sparkfishes
    @sparkfishes 4 місяці тому

    The title should say what it is for: what it does. Use flux and save all that scraping and it allows soldering at a lower temp AND it is quicker

  • @arunkamble3140
    @arunkamble3140 Рік тому +2

    Pls explain diode connection again, it's confusing. Also pls tel me about power supply in and out

  • @user-ye6eb9fv4d
    @user-ye6eb9fv4d 3 місяці тому +1

    hi i think the connection is correct , but i think there was an error in the drawn diagram because in the diagram the motor feed terminal was connected to the NC for relay and this incorrect .. thank you for your efforts

    • @kokor7409
      @kokor7409 Місяць тому

      I agree with you. The NO and NC are reversed.

  • @dhimande2646
    @dhimande2646 Рік тому

    Beautiful

  • @mariobv947
    @mariobv947 Рік тому +2

    If you don't want to use a diode because of low max current capable and wasting power due to the voltage drop, Just use a P-Type Mosfet for positive rail protection, or N-type one for negative rail protection. Just put in series by forwarding the mosfet body diode, and then tie the gate to the other rail throught a few hundred ohms series resistor (not really necessary but for safety in case the mosfet becomes shorted).

    • @mariobv947
      @mariobv947 Рік тому

      A single IRF3205 can hold up to 110A (but don't try to push beyond 50A). Anyhow you can put in parallel as many mosfets as you want for hundred amps.
      The current through the gate is virtually 0, and so the voltage drop through drain and source.

    • @sparkfishes
      @sparkfishes 4 місяці тому

      Show diagram please ...somewhere it would help understand mosfets also

  • @BangboSeries-hl6je
    @BangboSeries-hl6je 7 місяців тому

    Weldone 🎉

  • @nl6524
    @nl6524 Рік тому +1

    Very nice 👌 bro 😘🇧🇩🇧🇩🇧🇩

  • @user-sb1lw4yh3w
    @user-sb1lw4yh3w 7 місяців тому

    Gracias

  • @techwitharif471
    @techwitharif471 Рік тому

    Nice ❤️👍

  • @plvkgamer1674
    @plvkgamer1674 Рік тому

    Sir please make a video for radio( MW signa)l detector

  • @digitalmachine0101
    @digitalmachine0101 6 місяців тому

    G00d information

  • @sujannaik4280
    @sujannaik4280 Рік тому +8

    we can use a single diode for polarity ?...

  • @tubankota8962
    @tubankota8962 9 місяців тому

    Menggunakan relei brpa vol booos

  • @singingzone3056
    @singingzone3056 Рік тому +1

    Nice

  • @prasetiosudjiastoto4754
    @prasetiosudjiastoto4754 Рік тому

    What is the project name ?

  • @klinikartomoromotor801
    @klinikartomoromotor801 14 годин тому

    Indonesia hadir

  • @techwitharif471
    @techwitharif471 Рік тому

    Nice Video 🇧🇩

  • @malkhatelectronicsphephana2048

    Very mst

  • @backtovillage1
    @backtovillage1 5 місяців тому

    Why we don't use simple diode instead of this

  • @user-bg5vo1wk9q
    @user-bg5vo1wk9q 11 місяців тому

    Братан сделай схему для лабараторника от 0 до 30 вольт переполюсовки 👍

  • @alfatihid8901
    @alfatihid8901 7 місяців тому

    You Just need 1 diode for polarity protection lol

  • @hawielectronic
    @hawielectronic Рік тому +1

    أثناء عمل الدائرة، الريليه سيسحب التيار مع الماتور وهذا يستهلك البطارية والتيار، اجعل الدائرة تعمل ولكن الريليه لا يكون في حالة عمل بل يكون في حالة توقف واجعله يعمل فقط في حالة قلب الأقطاب، حتى لا يكون هناك استهلاك للتيار وشكرا على الدائرة وهي عملية وجيدة.

    • @hassanaitabbou2478
      @hassanaitabbou2478 Рік тому

      اخي الكريم كيف يمكن لروليه ان يعطي هذا الامر دون ان يلقى يسهلك التيار
      ولك مني كامل التشكرات
      ارغب في استعمال هذا الحل في السقي بالتنقيط وشكرا مسبقا

  • @adilabusafa
    @adilabusafa Рік тому +1

    يتعذر الاشتراك لا يوجد جرس-يتعذر الاستجابة لكل طلباتك-يتعذر التعليق - لا أعلم .

  • @EarphoneReview
    @EarphoneReview 9 місяців тому

  • @MyWorkNVk
    @MyWorkNVk 10 місяців тому

    Trống ngược cực

  • @ikhoChvolume12
    @ikhoChvolume12 11 місяців тому

    Itu yg lakukan hari2

  • @user-gr6yl8zk3e
    @user-gr6yl8zk3e Рік тому

    Свойства диода

  • @joseantoniogomeznavarro8784
    @joseantoniogomeznavarro8784 Місяць тому

    diodo 1n4007 mal colocado

  • @devendranapit9923
    @devendranapit9923 Рік тому

    कोई भी कार्य करते समय मुझसे भी बदला या जाए

  • @natureshine5117
    @natureshine5117 Рік тому +2

    Bhai hai kya ye bnayaa kya hai kuch banane ki koshish kar rhe the kya 🤣🤣🤣

  • @sopraglorificarsantos1453
    @sopraglorificarsantos1453 10 місяців тому

    Muito ruim vc assistir um vídeo ouvindo barulho de som

  • @mssarmenakter6009
    @mssarmenakter6009 8 місяців тому

    কাজ হচ্ছে না

  • @rleonmx
    @rleonmx Рік тому +1

    que chafa, un simple diodo haria el trabajo

  • @user-wi5hn7wy3d
    @user-wi5hn7wy3d Рік тому

    НУ и для чего СЕЕ хав но,для просмотров?

  • @stingray1951
    @stingray1951 Рік тому

    Rubbish as usual

  • @math-electric2049
    @math-electric2049 Рік тому +1

    Nice