Moisture has been detected - How To Fix Samsung S9-Motherboard Repair
Вставка
- Опубліковано 21 сер 2024
- Moisture has been detected - How To Fix Samsung S9 - Motherboard Repair.
Moisture detected error happens a lot on Samsung phone charging. In most cases, it is caused by charging flex cable faulty. Hence in the first place, we replace the charging flex cable with a new one. However, the problem still exists. Then we test the motherboard and find out that the OVP IC has been faulty. We replace a new OVP IC and problem solved. - Наука та технологія
Any Repair Ideas or Repair Cases you wish to see most ? Leave a comment below.
Can i just use the dryer or the rice to dry the moisture for Samsung Note 9 ?
That won't work for water inflow on motherboard
If possible videos troubleshooting mother board by power supply test flow amper upload🙏🌹🌹
Where is your location sir?
Please show us faults you find using standard DC Power Supply and explain the errors shown by the current it pulls...please sir
Hey, great work, but I gotta quick question. Do you know where I can find the reballing stencil for samsung devices?
Very professional.💙
Even photography and editing are creativity
Great video. Thanks
: )
love from indonesia GOD bless you bro... temp 400' and air 40 i will try latter..
Can this be a software error or is it always hardware like charge port, cable or this chip? I'm looking at A52s.. Port and board looks pristine under the microscope and cleaned with ipa. While messing around rebooting it started charging later on... Just not sure if the error will come back.. I guess a factory reset could eliminate software error but then need to backup etc, just wondering if you know? Is there anyway to disable in hardware? I looked at a datasheet for another OVP chip though, seams probably cannot disable since no sensor, it is just detecting a lower resistance across the pins for moisture!
Also the error only occurs when the battery is dead and the phone is off, if I charge the battery from the bench and boot up without the cable in then it will charge normally until it dies and turns off again!
Many thanks, great video....
If there is no actual moisture the error will most likely come back and will start happening even when the battery still has charge. It's pretty poor from Samsung
I have the same issue, what was the solution?
Sometimes, my cable says USB disconnected. Sometimes, it won't use super fast charging. And after 6 months I got the dreaded moisture warning again and managed to keep restarting till it went. I had the port replaced at a tech and he said it isn't the port but maybe the motherboard.
Nobody seams to know! It's not the port! I would love to know, I have several customers ask me..@@pakanon1
Device wasn't faulty he just removed the IC and replaced it.. because s9+ devices will show error while charging if u remove wireless charging pad.. first 2 times he showed by removing the pad.. at last when he tested with pad mounted..
where could I find out the datasheets of samsung s9? I ask you that because I dont know how you know the normal values of the resistances
That's easy. We just test a normal Samsung S9's resistance and record the value.
they test another normal unit of s9. and use the reading as standard point for repairing this phone.
God Job from Indonesia
Your videos prrety useful thanks
Thank you!
Good job
Cost you charge for IC repairs in general for any phone.
Can also be a bad cable as i just had one do the same but was cable :)
Same here
Outstanding job 👏👏👏
:)
@@CINOTechnology hello sir I want to repair my mobiles please tell your location and it how much cost to repair this type of condition .
my cellphone is s9 scv38 after removing the rf ic why does it restart after 1 minute even though in safe download and recovery mode it never restarts, and I have reinstalled it smoothly but after entering the menu in 1 minute it restarts again
Does not rule out software problems
thanks! I'm doing the process right now
Can you fix with same problem
How did you open your phone as a service centre suggested me that they open the phone via some sort of vacuum machine which would result is breaking my display as it has a little crack at the bottom. Please suggest some help. Thanks in advance.
Use screwdrivers, pry bar, hairdryer to open the phone.
I use my fingernails
Good job.... Nice video
Do you have any whatsapp group
CINO Technology WhatsApp +86 13410892094
@@CINOTechnology thanks
Good
Job well done
Thank you!
Can it be a battery problem?
Just use cordless charger and problem bypassed and solved
You are great. Sometimes the problem is not serious
Cordless charger charges too slow.
Bravo ... I have the proplime my divace S8
Fix it
@@CINOTechnology I have a Question ..
Misguided solution, you have checked without wireless charging pad earlier then later you have checked with charging pad.
Hello sir exactly my mobile happend this condition where can I fix this and how much cost it takes,
CINO Technology WhatsApp +86 13410892094
❤❤❤❤❤❤❤❤❤❤❤
my phone is galaxy a71. problem: it doesn't show the waterdrop logo. but only the flassh in circle logo. is my problem can use this same solution?
Check out your display
@@CINOTechnology thank you
if it were a t-mobile device, could i replace it with a verizon motherboard?
Should be OK then you have a Verizon phone instead.
What is the rate of air flow for 400 degree
30
So it doesn't need to reset to factory the phone?
You can factory reset your phone before doing motherboard repair.
@@CINOTechnology thanks!
wow i didn't know that samsung is pain in the ass
It keep charging and discharging😢
How much money will be spend to replace components?
The components themselves cost not much: www.cinomall.com/collections/galaxy-s9. It costs more for the service charge.
Got I'm not that smart
You can do it too
where can i buy this chip?
never mind i Found it, FPF3688UCX VH VHAN on aliexpress.
Good
@@star2gates thanks bro
Moreee Android phones
We will try our best.
Can i send my mobile to you to fix
of course. CINO Technology WhatsApp +86 13410892094
Your WhatsApp not working
Wow.
: )
Ya ofcourse cuz everyone just has an extra and the time to do this shit 😅
after all you have your shit time to leave this comment dont ya
Where is your technology sir
Shenzhen, China