Це відео не доступне.
Перепрошуємо.
Changing Crankshaft Sensor on 2006-2012 Nissan Sentra MR20DE 2.0 Engine P0335
Вставка
- Опубліковано 7 кві 2022
- A simple job, but you do need to get under the car
This is one potential cause of a no start or long crank to start condition
I recommend buying the Nissan one if you don't have a preferred aftermarket brand: Nissan part: 23731T
Time: ~15 minutes or less (longer if you don't have everything ready)
Tools:
8mm 1/4" drive socket I prefer deep for the added extension
10mm 1/4" drive socket
short extension 3/8" or 1/4"
3/8" drive ratchet A 3/8" gives a bit more leverage
3/8" to 1/4" drive adapter
jack & jack stand
or
ramp
Your phone's camera or an inspection mirror are helpful for seeing where you can't see
An ODB2 reader to clear the check engine light, if needed
Need to know how to get the wires in order... my connector broken
thank you good job
99poopoopp
Saludo, necesito saber cómo van los colores de conector
Do I need to unplug the battery first?
You should anytime you'll be under a car just in case someone decides to start it up. even as a prank. I didn't when I did this one.
Definitely not a 15. I did it on mine and it took 2 hours cause it’s such a tight spot
Using the tools I called out it isn't a 2 hour job. Using a wrench of if your have numb fingers or bear paw hands it might be. You do need to do most of it by feel (or with mirrors). I looked at the time stamps from when I filmed it: 12 minutes 27 seconds from start of filming until the last clip I filmed I ended, and that is with moving the camera and a couple retakes.