Hi Did you test the heat pump terminals 2 and 3rd terminal (red wires) - it should be 20ohms. If it's open circuit then you get E09. The pump price in Australia is $220 and about 1.5hrs to remove and install/test. I would give this a go before looking at PCB
Isnt it that there are two relays because the pcb is universal and one relay is for a pump heater and the other one for a zeolite heater? It sounds logical to me... there are 5 pins coming out of the board and dishwashers without zeolite dont utilize all of them.
Yeah you can remove the clips holding the motor housing to see the element. Once disassembled the sealing integrity is compromised and the whole heat pump should be replaced
Did you repair this pcb or buy new?
Hi
Did you test the heat pump terminals 2 and 3rd terminal (red wires) - it should be 20ohms.
If it's open circuit then you get E09. The pump price in Australia is $220 and about 1.5hrs to remove and install/test.
I would give this a go before looking at PCB
I replaced the pcb the board to fix the issue
@@theoracle6005 I have made repair on the pcb, but although it’s filling now, the heater is still not working
@@firmbutton6485 I would say check the heater on the heat pump and replace if necessary
Isnt it that there are two relays because the pcb is universal and one relay is for a pump heater and the other one for a zeolite heater? It sounds logical to me... there are 5 pins coming out of the board and dishwashers without zeolite dont utilize all of them.
Well the zeolith is in the heat pump.
2 pins activate the coil and 3 pins - Normally open, Normally closed, and common
@@theoracle6005 no zeolith has a separate heater
Does you unit have a dryer as well ? If so there is an additional zeolith.
If my knowledge serves me right the zeolith is a printed heater around a round metal surround
@@theoracle6005 zeolith minerał has a separate tank and a heater in it.
I wonder if we could see the heater element inside pump.
Yeah you can remove the clips holding the motor housing to see the element. Once disassembled the sealing integrity is compromised and the whole heat pump should be replaced
@@theoracle6005 thanks, do you know about diagnostic menu in SMS seriese ? There is no any guidance about it
There is very little information, but when u replace the board it has a diagnostic startup