Not judging the way you do things, but it might be easier in the future if you take a 2x4, c clamp with the socket and a bit of pool lube to press that instead of hammering.
@@chuckcunningham2786 I would step on the go switch and nothing would happen and then it would just turn on. I had some dead spots on the armature from the leakage.
Nice job. Appreciate the content. Have an ultrex so this will come in handy if I need to change the armature. What were the symptoms of the bad armature?
You used a "straight" electrical connector???? I'm doing mine now and I couldnt fit the straight one in. It comes stock with a 90° "f" connector, which I cant find. How did your fit in there??? Also you should torgmque those long bolts at 40" pounds.
thank you, just replaced mine today, thought season was over, such a simple fix
Isn’t the prop side shaft seal on backwards? The seal spring is exposed to the water with it like that…
Asking the same here
Nice man. Was looking for a good refresher video since it's been a while since I tore mine apart. Replacing it all tomorrow. Those damn brushes 🙄
Not judging the way you do things, but it might be easier in the future if you take a 2x4, c clamp with the socket and a bit of pool lube to press that instead of hammering.
Nice video appreciate for sharing
good video! I think my Ultrex has water intrusion again so I'm going to tear into and see what's up.
What did your ultrex do to make you think it had water damage. My prop has stop spinning.
@@chuckcunningham2786 I would step on the go switch and nothing would happen and then it would just turn on. I had some dead spots on the armature from the leakage.
@electriceye3942 That is what mine is doing also. I need to find the armature kit. Will you please send me that information.
Nice job. Appreciate the content. Have an ultrex so this will come in handy if I need to change the armature. What were the symptoms of the bad armature?
Nice work
You used a "straight" electrical connector???? I'm doing mine now and I couldnt fit the straight one in. It comes stock with a 90° "f" connector, which I cant find. How did your fit in there??? Also you should torgmque those long bolts at 40" pounds.
Where did you get the kit?
I need to replace my armature also. .i have 36v 112 torque. Did you find the kit?
Has anyone found the exact location of water intrusion? Mine is leaking for the third time and I'm done with the dealer
Where do you get the stabilizer peace goes between the 360 and the trr trolling motor shaft ?
It's a Precision Sonar 360 stabilizer