Make more money of course smh why don't people understand its all about the dollar money in labor and parts to repair it bs it lasting forever no brainer
So stupid people don't have to move their arm and can just press a button instead. But then it breaks and we have to spend $500 in time parts and labor so lazy people don't have to interact with something manually.
The shift actuator on the transfer case is the issue with the front not engaging. It has a fail safe system; is closed loop, undiagnosable with anything. Same with my taco. Pop it out install a new one, probably got water from crack vent tubes, lengthen them and raise the vent higher.
Great job! Question: why did it seem like the front wheels were rotating slower than the rear wheels. I suspect this is by design - but what its the rationale?
I don't know why but something I think is wrong. My 1999 Tacoma I have owned since new vibrated when it was relatively new because I left it in 4x4 on a hard top road. I realized I was in 4x4 and placed it in 4x2. When I got my oil changed later I asked them to lift it and see if the 4x4 still worked. It did but from memory they were spinning the same speed. Hope fully Peter will answer you question. Great question.
The left front was not rotating the same speed because it’s a floating differential. If you noticed the right front wheel was keeping the speed of the rear wheels. Think of it as if the right front wheel was losing traction, and the left front wheel was not losing. That’s why the right front was spinning faster than the left front wheel.
I replaced this part and fixed my problem, but new part has a short breather pipe and a bung in it , seems to be glued on. Is this a new mod and how it should be, or does it need to be pulled off and put on old breather???
Is it best to replace and add new Differential fluid when replacing the front actuator. And when replacing the actuator do you have the 4runner in 4H or 4 wheel drive off?
Hi. Good information. I went a step too far and opened the ADD. Parts are cleaned BUT require assistance retiming the unit. Any possibility of providing information or a link. Cheers. Frank
Hi, I've been watching your videos and learning a lot from them. I figured out the problem with the 4 wheel drive of my 1999 Toyota 4runner - the 4wheel drive works and everything but, the 4wheel drive light flashes every time I start the vehicle. Do you have a suggestion of what is causing the lights to flash? Thank you in advance.
Do you think you could advise me where to start.. I recently acquired a 1991 land cruiser. It’s stuck in center diff lock. Light is on in dash and won’t go off from toggling the button or from placing transfer case from high to low and back. Please help
I have a 2010 CrewMax Platinum Tundra with code: C1340, which my code reader says it's the Center Differential Lock Circuit. My 4WHi/4WLo dont work at all. Any idea what the part# is?
I believe that my 4H works, but when I put mine in 4L then I get a constant beeping. Someone said to engage it then disengage it a few times and it should free up, but no luck. What should I do next? Thanks and another great video!
FIPG, very expensive. Good for you for using it. I see the old red silicone, maybe someone was in there before? 7:26 driver is a fan of the fancy mexican music? haha.
Boss when it gets to this point is when they ship it to 3rd world country’s where it will be put the most torture it’s ever received amd last another 10 years with the same tires and zero maintenance
So that's not diff lock it just engages 4x4??? My hilux has this and I thought it was electronic diff lock, my Pathfinder locks 4x4 in the transfer case, I don't see the point.? Why not just use the transfer case like every other 4x4 I've worked on
I too noticed the speed difference between front and rear wheels and found that a bit strange. I have not been wrenchin on Toyotas, only LR's and they have 50/50 atleast my Lr3 does Anyways, good video Peter, but perhaps you could show us a bit more og how you do your repairs, like Eric O over at South Main Auto does.. Just a thought
@@pellethoresen4025 it has a Torsen transfer case. The transfer case distributes torque 40/60 in a straight line with no resistance. This changes in turns or with a slipping wheel or axle.
In the first video Petr showed the computer codes, I remember a front wheel speed sensor, a rear wheel speed sensor, one or two O2 sensors, plus tires, dangling taillight wires, plus a little more - really not that bad to fix, it would take a do-it-yourselfer about a full day in his driveway..
I was going to say that too. I thought maybe only one rear wheel was turning which would make the other rear wheel spin at twice it’s normal speed, but both rear wheels were spinning fast and both front wheels were slow. I don’t know.
Probably just the center diff not spinning evenly because I’m of the different resistances between how smooth the rear diff is able to turn from the front
Great explanation but this design is nonsense. I would much rather have a bullet proof mechanical engagement shifter as part of my console in the interior. But Toyota (and others) like to add electronics to as many things as possible (even water [coolant] pumps) now apparently on some models.
Thank you for the video. The actuator just slides the collar to complete the right axle to the differential assembly.
❤❤❤thank you very much idol shout out from Philippines
Great job, wow that does move very easily. I wonder why Toyota moved away from the old school shift mechanism versus a electronic actuator.
Make more money of course smh why don't people understand its all about the dollar money in labor and parts to repair it bs it lasting forever no brainer
So stupid people don't have to move their arm and can just press a button instead. But then it breaks and we have to spend $500 in time parts and labor so lazy people don't have to interact with something manually.
The shift actuator on the transfer case is the issue with the front not engaging. It has a fail safe system; is closed loop, undiagnosable with anything. Same with my taco. Pop it out install a new one, probably got water from crack vent tubes, lengthen them and raise the vent higher.
“Apparently they use it in the hills” 😂 apparently
Great job! Question: why did it seem like the front wheels were rotating slower than the rear wheels. I suspect this is by design - but what its the rationale?
I don't know why but something I think is wrong. My 1999 Tacoma I have owned since new vibrated when it was relatively new because I left it in 4x4 on a hard top road. I realized I was in 4x4 and placed it in 4x2. When I got my oil changed later I asked them to lift it and see if the 4x4 still worked. It did but from memory they were spinning the same speed. Hope fully Peter will answer you question. Great question.
I saw that problem it is just tighter gears in front the rears are looser
The left front was not rotating the same speed because it’s a floating differential. If you noticed the right front wheel was keeping the speed of the rear wheels.
Think of it as if the right front wheel was losing traction, and the left front wheel was not losing. That’s why the right front was spinning faster than the left front wheel.
Been waiting for this video. Thanks
How did you get the last bolt out? Swivel Head with extension and another swivel?
How did you get to the top two bolts?
I replaced this part and fixed my problem, but new part has a short breather pipe and a bung in it , seems to be glued on. Is this a new mod and how it should be, or does it need to be pulled off and put on old breather???
Is it best to replace and add new Differential fluid when replacing the front actuator. And when replacing the actuator do you have the 4runner in 4H or 4 wheel drive off?
If you replace all the bad parts you will have a brand new Toyota that will last forever
Hi. Good information. I went a step too far and opened the ADD. Parts are cleaned BUT require assistance retiming the unit. Any possibility of providing information or a link. Cheers. Frank
Thanks for sharing this video, thanks
Hi, I've been watching your videos and learning a lot from them.
I figured out the problem with the 4 wheel drive of my 1999 Toyota 4runner - the 4wheel drive works and everything but, the 4wheel drive light flashes every time I start the vehicle.
Do you have a suggestion of what is causing the lights to flash? Thank you in advance.
Do you think you could advise me where to start.. I recently acquired a 1991 land cruiser. It’s stuck in center diff lock. Light is on in dash and won’t go off from toggling the button or from placing transfer case from high to low and back. Please help
Hey Peter...I'm the first to watch this video!
Winner winner reuben sandwich dinner
That was very informative and another success- BUT that engine doesn't sound too good either!
When you install the ADD actuator do you make sure the fork is set to install in the disengaged position? or the engaged position?
Did you find an answer I’ve got the same problem? I’d assume 2nd position?
@@harrisongauci2487DUDE. I was so frustrated I gave it to a mechanic shop. They uninstalled and re installed it and it just worked.
I have a 2010 CrewMax Platinum Tundra with code: C1340, which my code reader says it's the Center Differential Lock Circuit. My 4WHi/4WLo dont work at all. Any idea what the part# is?
The 4Runner looks like it fell from great height out of the back of a C-17 without the aid of a parachute.
It did, the Taliban couldn’t use it!😆
1987 Fort Bragg USAF Hercules LAPES (parachute) tank drop crash?
Do you not have cordless tools? . Love your videos btw
Oh, that poor vehicle... It's sad to see the how it's been abuse. But it's still kicking!
Did the 4WD lights ever stop flashing?
Hi, how to replace it in a 4runner 2001, please
I believe that my 4H works, but when I put mine in 4L then I get a constant beeping. Someone said to engage it then disengage it a few times and it should free up, but no luck. What should I do next? Thanks and another great video!
Any luck with your 4L issues? I have the same problem with my 05 tacoma. Just keeps beeping....
FIPG, very expensive. Good for you for using it. I see the old red silicone, maybe someone was in there before?
7:26 driver is a fan of the fancy mexican music? haha.
Boss when it gets to this point is when they ship it to 3rd world country’s where it will be put the most torture it’s ever received amd last another 10 years with the same tires and zero maintenance
Looks like it came from Yemen.
Car Wizard just talked about why the extremists always use Toyotas over the M/E. Very funny comments. Reliability.
Change differential oil together?
Curious, what did you torque those bolts to? Or did you just go snug then a quarter tight?
The FSM for a 2005 Sequoia says 15 lb-ft - I would imagine the 4Runner is very similar
So that's not diff lock it just engages 4x4???
My hilux has this and I thought it was electronic diff lock, my Pathfinder locks 4x4 in the transfer case, I don't see the point.?
Why not just use the transfer case like every other 4x4 I've worked on
Great job
I am curious about the speed the front wheels were spinning. I thought they would spin at the same speed as the rear wheels?
Different axle ratio, and power distribution isn't 50-50.
I too noticed the speed difference between front and rear wheels and found that a bit strange. I have not been wrenchin on Toyotas, only LR's and they have 50/50 atleast my Lr3 does
Anyways, good video Peter, but perhaps you could show us a bit more og how you do your repairs, like Eric O over at South Main Auto does..
Just a thought
@@pellethoresen4025 it has a Torsen transfer case. The transfer case distributes torque 40/60 in a straight line with no resistance. This changes in turns or with a slipping wheel or axle.
I see a long-term project vehicle that could help fund your retirement!
Fund? I was thinking bankrupt it.
Ever check the abs ecm. Get rid of the Christmas trees
In the first video Petr showed the computer codes, I remember a front wheel speed sensor, a rear wheel speed sensor, one or two O2 sensors, plus tires, dangling taillight wires, plus a little more - really not that bad to fix, it would take a do-it-yourselfer about a full day in his driveway..
Hi Peter, I have sent you an Email...about a strange problem with our Rav 4
WOW great info. AAAAAAAAAAA++++++++++++ again great video I liked it a lot keep up the great work
Don't you have vehicle inspections in California?
Emissions only
Why did the front wheels rotate significantly slower than the rear wheels w/4wd engaged?
I was going to say that too. I thought maybe only one rear wheel was turning which would make the other rear wheel spin at twice it’s normal speed, but both rear wheels were spinning fast and both front wheels were slow. I don’t know.
Probably just the center diff not spinning evenly because I’m of the different resistances between how smooth the rear diff is able to turn from the front
I forgot some 4 runners came with a center differential. I was thinking of a transfer case.
@@kb9knd yeah it even stumped me for a minute and I have a 4th gen 4Runner 😂
This is what you call a Piñatamobile....
what are the torque spec on the 4 bolt ?
14 ft lbs
I thought it was Tigers car.
They need a manual cable and lever .
Piss on that electric mess.
Mines out again
never showed how you removed it thanks
Great explanation but this design is nonsense. I would much rather have a bullet proof mechanical engagement shifter as part of my console in the interior. But Toyota (and others) like to add electronics to as many things as possible (even water [coolant] pumps) now apparently on some models.
Hope you are getting paid
The Tacoma abused by Top Gear years ago was in better mechanical shape than this.
Not a Tacoma
@@graysonwilson3483 A regular pickup, Tacoma's father. Possibly even better built.
I’m glad you opened the top plug first, because you wouldn’t be able to fill it if it broke. 😂
Now it's ready for the demolition derby.. Lol
Replace it with the spare. Problem solved.
In Swahili language
That seems its a pretty simple setup. Leave to Toyota .
Dude $1500 bucks for it.. I'd fix it and sell it for $7k
Lol I just paid $2700 for a 99 Toyota Prado V6 that's been rolled, they want 5k just for the motor. I'd pay more than that to wreck it.