Thank you very much for the video!! I have followed your instructons and now I have a brand new key. I have just one hint for you: use a small knife to take the pieces apart. It's less damaging than a screw driver.
Thank you so much!! Every video was wrong about the rubber piece putting it on. Spend 45mins trying to get it together and didn’t realize the plastic piece can come off.
Only just seen this and must say a huge thank you for it. Struggled over the last few days trying to get the rubber bit back into the key itself. No-where it seemed told me BUT at around the 12:20 mark, you pop another thing out of the key and then fit the rubber. So easy now and I have a nice looking key again - thank you.
Hi excellent vid. Question tho. I have a seal unit which i breakapart to remove pcb. Swapped over pcb to the new part. Lock unlock all works but when key is inserted in the ignition it doesnt recognize and dont start the car. Any idea?
Yes, how do you replace the circuit board on a sealed unit? Actually trying to only replace the red light cover, but cannot figure out how? (W/O breaking the plastic)
![[UA] NAVI vs MOUZ | BO5 | IEM Rio 2024](http://i.ytimg.com/vi/CMBYk0cbGoA/mqdefault.jpg)
Thank you very much for the video!! I have followed your instructons and now I have a brand new key. I have just one hint for you: use a small knife to take the pieces apart. It's less damaging than a screw driver.
Thank you so much!! Every video was wrong about the rubber piece putting it on. Spend 45mins trying to get it together and didn’t realize the plastic piece can come off.
Only just seen this and must say a huge thank you for it.
Struggled over the last few days trying to get the rubber bit back into the key itself. No-where it seemed told me BUT at around the 12:20 mark, you pop another thing out of the key and then fit the rubber.
So easy now and I have a nice looking key again - thank you.
just had the same problem, and also thanks to your comment its fixed!!! Thank you both!!
Thank you so much. Excellent guidance. Thanks to you I fixed my remote 🏆
4.49pm thank you for such an easy tutorial to follow Im no good with these things and you don’t get pictures with anything.
I tried to buy this fob. But can’t find it on eBay. Is there a direct link to the item on ebay
Excellent tutorial video.
Kindly send me a link to purchase this exact key fob
Hi excellent vid. Question tho. I have a seal unit which i breakapart to remove pcb. Swapped over pcb to the new part. Lock unlock all works but when key is inserted in the ignition it doesnt recognize and dont start the car. Any idea?
How do you open a sealed unit?
Thank you very much for the video otherwise I would have broke the crap out of trying to fix both of my key fobs. Porsche over engineer's everything.
Yes, how do you replace the circuit board on a sealed unit? Actually trying to only replace the red light cover, but cannot figure out how? (W/O breaking the plastic)
Have you found out i would like to know aswel?
do you have more of these Porsche key-fobs? I need two. thx
Where can I buy this?
use an old toothbrush and clean those dust in the nooks and crannies so the pcs fit better.
Are you still selling this item? If so how much and do you have stock?
What? Why don't you show how to replace the PCB into the new fob???????????????????????? Worthless video without it.
Do you still sell these?
Hey just wondering how do you turn of the mods on you ps4 controller
Hi
Please message us through ebay.
Kind regards
Steve
Mastermodsuk
👍
Do you still sell these Porsche key fobs?