Cisco SD-WAN 009 - Service VPN1 Connected Routes via CLI and Templates

In this video, we will revisit Service VPN 1 but this time we'll set it up with the CLI and via Templates and see the difference!

[@floriancokl3142]

Thank you very much Rob for this wonderful series - fantastic job

[@liyvonne8846]

Hi Rob thanks for sharing the wonderful vedio. One question, how to wipe or delete one configuration which has been already pushed to devisces in Vmanager？ Like delete a configuration for vpn subinterface.

[@mariembuenaventura1278]

Hi sir, Do you have tutorial to setup the same topology you have? Like free? To easily follow the lesson... Thanks

[@RobRikerTechChannel]

Check the first video in the series, topology file in description

[@Newbility2010]

Hi Rob, got one question while watching the video, is the vSmart connected to both MPLS and Internet?

[@RobRikerTechChannel]

Yep

[@Newbility2010]

@@RobRikerTechChannel how would you suggest to do that in real production network? Could vSmart to be configured with two network interface, one facing to the Internet and one facing MPLS? Also can you configure vEdge with two vSmart IP addresses, one is the IP in MPLS and another is the NATTed IP on Internet? Both are actually pointing to one vSmart.

[@RobRikerTechChannel]

The vSmart connection is the control plane. So as long as 1 transport can reach it, your fine. This doesn't affect BFD or IPsec Tunnel connections between the WAN edges, vEdge or cEdge.

[@kaiye3859]

got one question, to simulate real environment. from internet, do we get able to ping from vbond to vmanage, vbond and vmart? or we need only ping to vbond? meaning from vedge can ping vbond but not allow to ping vsmart and vmanage?

[@RobRikerTechChannel]

The vEdge should be able to communicate with all of the management devices. Not sure what your trying to find out.

[@danilotorlai3916]

Do you know if there is any way to rollback the config on vManage for the devices managed by vManage Templates? I mean, like CLI command rollback configuration

[@RobRikerTechChannel]

Not to my knowledge.

[@joshuawang6953]

There is an option when you go to the last step of apply the template, on the left bottom corner, there should be an option, basically it says you can apply the template after few minutes it gonna rollback,you can define the timer there.