Land Cruiser 2008 model 2UZ V8 Engine how to change new Camshaft oil seal

[@mechanicven]

Bro salamat sa pag share mo ng iyong video malaking tulong to sa mga d pa naka experience mag palit ng oil seal

[@mytickets]

You must preload the scissor gear before reassembly if you have not put in the 6 mm holding screw

[@angbuhaymikaniko8698]

paano mo nasabing ganon

[@thomaskoemel]

How do the cam sprockets line back up ones you reinstall the cams?

[@angbuhaymikaniko8698]

thers a timing marks in intake sprocket ang exhaust sprocket you put in inline and thats it your good to go

[@abh1945]

Can I do this method for land cruiser 2013 v6 1gr fe?

[@angbuhaymikaniko8698]

No its not the same engine design.

[@joboysamonte9484]

Magandang Araw sir! tanong ko lang, Nag lagay po ba kayo ng lubricant sa bagong 'Seal' bago ilagay?

[@kylencannon1524]

instaBlaster

[@shoaibali4961]

💘

[@AbidHussain-mv9zy]

Work is good but you safty Zoor take hand golve dot not use mate hamber if theet damig what you do use Plastic hamber Safty Fist if your finger damage what you Do

[@Lunas2525]

And the timing syncros never worked again...

[@wyomikey65]

aren't those on the exhaust shafts? just saw a video about "locking" the exhaust gears before removal

[@hatifhaftif5376]

،👍

[@ShineWeather]

Hawud na jud kaayo na ana Doy

[@angbuhaymikaniko8698]

halos adlaw adlaw gabuhaton ta na maanad ra gyod hehe

[@pojdiavaj1422]

All this just for the stupid seal!
At $100hr, the dealer loving it

[@angbuhaymikaniko8698]

I agreee they want more money! thanks.

[@zakariasheikh243]

zakaray

[@dangda-ww7de]

No torque needed.

[@outdoorexplorationgear5070]

72 inch lbs is approximately 4 ugga duggas with a half inch impact. 🤣😯😯😯

[@angbuhaymikaniko8698]

you need it sir!

[@cgolden2640]

They are super tight from factory, book says 181 ft lbs