thank for this informative video. when you say cavity is around the housing at 4:01 mark, do you mean it is a grove all around 360 degree on the plug... a picture of actual assembly will help.
One small dought sir , if left side track not cutting properly, some times strucked when cutting but We go straight two tracks properly. What is the complaint. Please tell me sir
Thanks for the comment, please have a look at our other videos too and rate us.
Thanks bro for unlawful video
Thank you so much 💓
I want to put a two way rotary coupling between Shaft & Motor to pass two different liquids . How it can be done ?
Well explained sir. I was searching for this video and it is only your video which I found very informative.👍
Thanks for the comment
i am going to try and run one of these up on a lathe, what kind of tolerance is there between the outer housing and internal rotor?
thank for this informative video. when you say cavity is around the housing at 4:01 mark, do you mean it is a grove all around 360 degree on the plug... a picture of actual assembly will help.
Awesome explanation
One small dought sir , if left side track not cutting properly, some times strucked when cutting but
We go straight two tracks properly.
What is the complaint.
Please tell me sir
Thank you very much my dear and thanks to JCB
Thanks for the comment.
i understood clearly and could u please tell me how to maintain pressure in tracks while varying load
hi there !! I'd like you to shear with me where I can fine the basic information design for this? textbooks and papers
Woooo nice sir 👏👏👏 great way of teaching 😘😘😘
I was searching in chrome bt here my doubts are fully clear thanksssss 😜😜🥰
Simply a marvelous video helped me a lot to understand the system. Kid you good
Nice explanation.. Plz refer a book where I can find something about rotary Union..
sir, how the hyd oil came back to the walblck throug return line
Thanks, for the motivation
Plz explain the motor case drain & pilot line ( i.e for swash plate angle changing) working in Rotary union
Thank you !! You make our life easy
Like good explanation
Nice video and really helpful. How return is possible?
Is that a new excavator design?
Nicely explained 👌👌
Thank you
Good explanation. Thank you.
How does the rotary union in mills work, please explain with diagram
Excellent 👍
Thanks for explanation, If it is animated it would have more better way of explanation.
thanks sir very helpful vedio
Thank you
Hi. What seals does this use?
Plug is not locked to cabin @2:41. Its bolted to superstructure (chasis) and cabin is a part of superstructure. Cheers
I didn't see how the middle piece supply continuous fluid flow to the housing.
good explanation...
Good job
i said cabin, ok u r right.
Sir, What is use of return pipe
nice
Pretty hard,but thank you anyways!haha
👏👏👏👍👍
Chassis is pronounced cha - see (like cha in chat) and not chases or any other abomination
Hindi me samjaye sir
Hindi
rahul kumar
How does the rotary union in mills work, please explain with diagram
thank you