I still like it. Never had the chance to test the newer version though. And based on the phenominal typing feel of the Envoy it might be good for my wallet to keep it that way :D
Have you done any force breaking to your sonnet? I have the brass bottom and have constant issues with hollowness. Any tips you may have would be appreciated
@saadkabbani65 Hi! No forcebreak on the case itself here, but plastic plates help an I added an additional oring and a washer to the isolated topmount. You need longer screws to do that though. What you can try, is polyfill in the case. But what helps the most is a soft plate imo.
I did notice that the POM plate was significantly better, maybe I can still improve it with your advice. Could you share the screw sizes and washers your used?
@ I'm Sorry but I don't have this information at hand. All I found was the o-ring info (because they are in my amazon shopping history :) It says: "sourcing map Pack of 250 O-rings sealing rings, 6 mm outer diameter, 2 mm inner diameter, 2 mm width, metric nitrile rubber seal for cream dispenser, pool pump, quick coupling, coffee cup" So I think they use M2 screws and therefore you'd need M2 washers too. I would suggest you first try polyfill (maybe from an old pillow) because it's no cost and the softer plate.
Audio- und Videoqualität mal wieder 110%!
Danke schön! Ist diesmal mit dem Zoom Recorder aufgenomen worden
showing the v1 some love
I still like it. Never had the chance to test the newer version though. And based on the phenominal typing feel of the Envoy it might be good for my wallet to keep it that way :D
Very nice. What is the cable you're using?
Thanks, man! Cable is from Keebstuff.com (a german custom cable shop)
Have you done any force breaking to your sonnet? I have the brass bottom and have constant issues with hollowness. Any tips you may have would be appreciated
@saadkabbani65 Hi! No forcebreak on the case itself here, but plastic plates help an I added an additional oring and a washer to the isolated topmount. You need longer screws to do that though. What you can try, is polyfill in the case. But what helps the most is a soft plate imo.
I did notice that the POM plate was significantly better, maybe I can still improve it with your advice. Could you share the screw sizes and washers your used?
Also did u remove the standard silicon isolation pads for the top mount? Or use both the orings and the silicon
@@Saadooness-n7d I used both. But I'm not so sure if it really does that much. Took over the solution from my Mode65...
@ I'm Sorry but I don't have this information at hand. All I found was the o-ring info (because they are in my amazon shopping history :) It says: "sourcing map Pack of 250 O-rings sealing rings, 6 mm outer diameter, 2 mm inner diameter, 2 mm width, metric nitrile rubber seal for cream dispenser, pool pump, quick coupling, coffee cup"
So I think they use M2 screws and therefore you'd need M2 washers too.
I would suggest you first try polyfill (maybe from an old pillow) because it's no cost and the softer plate.