Hi would there be a way for you to provide a diagram to install 2 WS100 with 24 G sensors in a double handicap door for home and what do i need to install it? A diagram that includes from the door controller sync connections to the Power Supply and accessory connections. the accessories i plan to use is an access control, 1 electric strike, 1 maglock, the remote controls, an exit button and the 24g sensors. i have looked at diagrams on the internet of how to connect the access control to the power Supply and then others to connect the door control, but i have never seen a complete diagram of the entire complete installation. Do I need a power supply? 12 volt or 24 volt? 3 or 5 amps? No, nc, fail safe, secure safe? I just need my doors to stay locked at all times if I don’t open them and in case of power out my doors to remain lock. Thank you. Good help. siv.
Hello I installed the 120 b at my mother in laws. Everything after a few tries I had it. The plastic remote worked the fob worked. Then I put the cover on. Neither the button nor the fob unless you were right next to it would it work. So I am Leaving the cover off until I can figure this out. Any ideas? Thanks in advance
I’m having a problem, I installed the system but the door is open to the outside when it ends
Hi would there be a way for you to provide a diagram to install 2 WS100 with 24 G sensors in a double handicap door for home and what do i need to install it? A diagram that includes from the door controller sync connections to the Power Supply and accessory connections. the accessories i plan to use is an access control, 1 electric strike, 1 maglock, the remote controls, an exit button and the 24g sensors. i have looked at diagrams on the internet of how to connect the access control to the power Supply and then others to connect the door control, but i have never seen a complete diagram of the entire complete installation.
Do I need a power supply?
12 volt or 24 volt?
3 or 5 amps?
No, nc, fail safe, secure safe?
I just need my doors to stay locked at all times if I don’t open them and in case of power out my doors to remain lock.
Thank you. Good help. siv.
Hi dear, can you please tell me your email address, so we can send you more information; or you can directly send me email at: sara@olideautodoor.com
Hello I installed the 120 b at my mother in laws. Everything after a few tries I had it. The plastic remote worked the fob worked. Then I put the cover on. Neither the button nor the fob unless you were right next to it would it work. So I am
Leaving the cover off until I can figure this out. Any ideas? Thanks in advance
Hi dear,
May I know if the button is wireless or hardwired?
@@OlideAutoDoor wireless
@@maniac1972 Maybe the signal is not good, please pull out the antenna in the the controller, and see what will happen.
I haven’t installed the sensor yet