Top Festool MFT Accessories
Вставка
- Опубліковано 16 лип 2024
- List of Festool MFT Accessoires
MFT Utility Rack - toolcurve.com/product/festool...
All Accessories - toolcurve.com/product-categor...
Dashboard Guide Rail Bracket Set - dashboardpws.com/products/gui...
Veritas Surface Dogs - www.leevalley.com/en-us/shop/...
TSO DoubleGroove Bench Dogs - tsoproducts.com/workholding-a...
Anderson Square - No longer available but we are working on an alternative
toolcurve.com - Наука та технологія
Heard this tip from someone else on web and it works. Try using a 2' x 2' of 3/4" square of MDF sheet goods. Most big box stores sell them for cheap as a project board. Pick one that does not have destroyed edges. It gets me to within cabinet square tolerances for setting up my MFT/3 with a touch of sanding of a few high spots. I usually find the squarest corner with my machinist square, then cut a diagonal to give me a lighter triangle at the end of one of the legs from that square corner. A quick cut off of the corners of the triangle and you should be good to go. Once the table is set up, I put it away so the edges are protected, till I start my next project, and I check again for square before starting. This usually passes the 5 corner test for square with a woodworkers needed level of accuracy.
DashboardPWS rocks! I regret I bought the Festool MFT/3 before I found out about the Dashboard PWS.
It might not be too late. We hear there's a thriving market in used MFT/3s.:)
The Dash-Board from Rob is awesome. I have what you're referring to as the older version (black and silver) and I'm no longer frustrated when I have to change the guide rail bracket height.
BTW, the setup square from Woodpeckers, if it's the one I'm thinking of, is phenolic.
Site of Utility rack can't be found 😢
Sloppy holes for the standard 19.90 benchdogs, you need 19.98 mm dogs.
WHERE are 19.90mm dogs standard? My dogs all measure either 3/4 inch (Workmate) or 20mm (Bora and Festool MFT).