Brilliant tutorial thanks. I was just about to replace my printer (it has been plagued with problems) but your video helped me get it going and I even had the part on-hand!
Dankeschön für Ihr Video es hat mir sehr, sehr...geholfen!!!!! Und mein Wanhao läuft wieder, wie NEU !!!!!!👍👍👍👍👍👍👍👍LG aus Germany Micha von Lemies Bastelgarage
And one small question: How long should the replacement PTFE tube be? Replacement tubing is available to be cut to length when installed but I can find no detail anywhere how long the replacement should be? Thanks.
Brilliant tutorial thanks. I was just about to replace my printer (it has been plagued with problems) but your video helped me get it going and I even had the part on-hand!
Thank you, I needed to see how to partially take the Monoprice Maker Select Plus and this helped a lot.
Thanks! Saved me jumping to conclusions and buying a new hot end!
Thank you man! I had a problem, searched help on the net and this video was the exact solution to my problem!
Dankeschön für Ihr Video es hat mir sehr, sehr...geholfen!!!!! Und mein Wanhao läuft wieder, wie NEU !!!!!!👍👍👍👍👍👍👍👍LG aus Germany Micha von Lemies Bastelgarage
Thank you, wonderful video. I will be able to fix my grandchildren's 3D Printer!
Amazing video, unclogged my printer ez. Life saver
Excellent presentation, thank you.
So at what point are you going to replace the hot end? you just replaced the nozzle
Great video. Lots of very careful and easy to follow details. Of course it's pronounced "zed" in Canada not "zee".
Thanks so much.
And one small question: How long should the replacement PTFE tube be? Replacement tubing is available to be cut to length when installed but I can find no detail anywhere how long the replacement should be? Thanks.
how long is the PTFE tube supposed to be?
is the I3 plus hotend a mk8 hotend?
Thank you❤
Well you didn't replace the hot end part! What about the part where the wires go into it?
Just to point out its easy to get the spacers the wrong side of the heat sink, which will undo all your good work
great video! thank you very much!
I wonder if thermal grease might help under that heat sink... ^_^
What am I supposed to do if my filament breaks mid print
Get better filament
Clean or replace the nozzle, recalibrate and print it again.
: