[REQUESTED] [HOW TO] CM.506 wiring disconnect to replace a stock
Вставка
- Опубліковано 6 вер 2024
- This is a requested video to show how to disconnect the wires on a CM.506 so that the stock can be fully removed and replaced.
I show how to remove it without any disconnection and how to further remove the connectors so the end of the wiring is removed.
Don't forget to like and subscribe!
Pheas
![[REQUESTED] [HOW TO] Double Eagle DE M904 motor change](/img/n.gif)
Useful video thanks Pheas some nice tips in there just what we need
Thank you so much for posting this video
Good info 🙂👍
See I was wondering about the what is under the heat shrink on mine, if it’s just a connector I can remove it and change my stock adapter because I’ve got a mosfet pre-installed so it doesn’t come out my wildhog buffer tube
Great video pheas just wandering if I wanted to change out the stock on my AEG would it be a swop or do I need to change the stock tube?
Hiya Stu! You should be able to just swap the stock. There might be a little wobble as not all stocks and tubes are the same inner / outer dimensions... Because everything being on the same specs would be... Sensible 🤣🤣 but a straight swap should be fine! Pheas
How long is that screw? ( I lost it and my buffer and stock are loose) and I couldn’t find any is the screws on airsoft webs
Hello, typically they are M5 screws with 3inch length or there abouts. You might need a slightly longer or shorter one though based on the specific model as some require longer screws (but still M5) and some require shorter ones. Pheas
Hi, can you play without the stock. The airsoft would be smaller and lighter, or is there a probleme with the spring? Greetings from Austria
Hiya. You would need to hold a battery in something, and the wiring, but that could be re-wired to the front and you could play without a stock easily enough. Pheas
Thx
Hey mate! Can you know how I can run a 507 M4 Cyma with LE STOCK. I know replica needs the Crane stock. (Which I am not a huge fan of.)? It is possible? Thanks anyway!
Hello! As long as you keep the lipo entirely in the Stock tube and the LE stock as an end cap on it, then you are good to go! Pheas
@@PheasAirsoft Thank you mate! I bought a lipo stick type. Well it's not going to fit in. But still kinda works.
@@PheasAirsoft I was able to fit a CTR stock too 👍🤓😇🙂.
How long is that screw driver?
Hello! its around 10 inches long this one. Pheas
Well just use sicissors and later just re soulder them
Yeah my little metal piece in the buffer tube will not come out
Hiya. hmmm, thats very very odd. It might need a damn good whack with a screwdriver and a hammer on the end of it to put some force. Good luck with it. Pheas