Renault Trafic Opel Vivaro Nissan Primastar / ECU Not communication

Поділитися
Вставка
  • Опубліковано 18 жов 2024
  • ecu not communicating Renault Trafic Opel Vivaro Nissan Primastar car not start found connected getting power reading fuel pump

КОМЕНТАРІ • 23

  • @xposeireland
    @xposeireland 6 років тому +31

    As helpful as a ashtray on a motorcycle

  • @kawasakikev8905
    @kawasakikev8905 6 років тому +8

    well that doesn't help , no explanation of what you're doing ...... nothing .

  • @pontesmocho3140
    @pontesmocho3140 3 роки тому +1

    Hi mate thanks for the great video.. I have the same problem. My Vivaro 2012 2.0. Doesn't start.. I have a error code DF067 injection multiplexed emission missing. Today I noticed that I do not have 12V on the wire of the ECU T2. Do you happen to know where this wire comes from? Or do you have the diagram? Thank you

  • @anna0sexy
    @anna0sexy 5 років тому +2

    There is a kill switch that kills the connection between the control unit and the fuel pump it’s on the left side in the Engine room and Coverd with a small Black rubber press it and the Engine will rum. This switch is usually there to kill the connection in case of an overflip of the car to stop the Engine.

  • @mrgasman9632
    @mrgasman9632 Рік тому +2

    And this is how you walk around your van 😂

  • @jamesbarratt593
    @jamesbarratt593 5 років тому

    Working on a vivaro that customer bridged blown 175 amp fuse with spanner. Main engine fuses power ripped by gear linkage mod in engine and shorted to ground. Change wiring complete and power to engine fuses restored. Still no coms. Had comp tested no issues. 4 relays were shorted so replaced red 5th checked out ok. High power to 5th showing .6 volt so not good. All fuses checked now too. Beginning to be a real diagnostic nightmare.

  • @Mark-gf7zs
    @Mark-gf7zs 8 років тому +2

    Hello, do you have already a solution for this problem? I have a trafic that does not start suddenly. when i read-out the car, there is no ECU connection

    • @MadmanCar
      @MadmanCar  8 років тому +5

      hello .
      In my case - Yes problem solved.clean the connections to ECU With chemistry and clean with the iron seam.
      I do not know how your problems can be wires

    • @tomtebloss89
      @tomtebloss89 7 років тому

      Hello, I got same problem with trafic, did you solved it ?
      Thanks

    • @hrantmelkonyan5471
      @hrantmelkonyan5471 6 років тому

      Hello, I got same problem with trafic, did you solved it ? Thanks

    • @anna0sexy
      @anna0sexy 5 років тому

      Mark I have exactly the same problem how did you solve it?

    • @MrSuperheterodyne
      @MrSuperheterodyne 5 років тому +4

      @@anna0sexy I saw it on another video that wires under the ECU rub on the steel, and then short out. Maybe check there. Also if you have the 1.9 make sure you take the air filter box off and check all the injector wiring under there. The air box rubs against the wiring and damages the insulation. I put washers under my air box mounts to lift it higher and give it some clearance from rubbing.

  • @rajamin1986
    @rajamin1986 5 років тому

    Hi all need serious help.. my vivaro does not start and is not communicating to ecu.

  • @luxyman1
    @luxyman1 5 років тому

    No one can talk anymore. That video helped me no end!!!! NOT

  • @martincornish3179
    @martincornish3179 5 років тому

    What was the point of that

  • @madalinionut4883
    @madalinionut4883 10 місяців тому

    Wtf dude ?

  • @mrgasman9632
    @mrgasman9632 Рік тому

    Wtf 🤬

  • @bigpimp347
    @bigpimp347 5 років тому +4

    so point of this video ???