There are several reasons that it could be. Does it spool if you set Governor mode = passthrough? The Arm mode has to be enabled on a switch separate from your throttle hold. The FC must see min throttle before it can be armed. The other reasons for Arm not being enabled will be dislayed with the arm disable flags on the Status Tab.
If you contact us using the Discord we can give you much better detail on what to do. It is an active discussion and there is always someone ready to help.
when I copy betaflight unified-targets and select the board, the pin column only shows "NONE" . I think it's something to do with the spreadsheet not recognizing the "space" between values. any idea why this is happening ?
Hi there. Please check you are using the most recent version of the spreadsheet. The link is in the wiki. It is currently v1.4.1. Please make sure you are I only selecting the line 'board_name' and below to be pasted in the betaflight list. 'board_name' must be the first line in the spreadsheet. There is also an updated version of this video. ua-cam.com/video/TNAeDaAjzfQ/v-deo.html
@@philkaighin3582 I made a short youtube video of screen captures. v=r6QUeYxApKE copied target will only show "NONE" on pin column, no matter what I do. I had to manually edit every line of existing target to make it work. if I copy existing column to a new column, it will only show "NONE".
@davidjacobs8558. Hi there. I have been away and have only just seen your video. It was a bit difficult to see what was happening. I added your target to the spreadsheet and it seemed to work fine. Please open the current file from the link and save a copy and the speedybeeF405V4 will be in the list.
Hello, I can't make my esc work already calibrating but even so it doesn't make the motor run... my motor and pwm
There are several reasons that it could be. Does it spool if you set Governor mode = passthrough? The Arm mode has to be enabled on a switch separate from your throttle hold. The FC must see min throttle before it can be armed. The other reasons for Arm not being enabled will be dislayed with the arm disable flags on the Status Tab.
If you contact us using the Discord we can give you much better detail on what to do. It is an active discussion and there is always someone ready to help.
when I copy betaflight unified-targets and select the board, the pin column only shows "NONE" .
I think it's something to do with the spreadsheet not recognizing the "space" between values.
any idea why this is happening ?
Hi there. Please check you are using the most recent version of the spreadsheet. The link is in the wiki. It is currently v1.4.1. Please make sure you are I only selecting the line 'board_name' and below to be pasted in the betaflight list. 'board_name' must be the first line in the spreadsheet.
There is also an updated version of this video. ua-cam.com/video/TNAeDaAjzfQ/v-deo.html
@@philkaighin3582 I made a short youtube video of screen captures.
v=r6QUeYxApKE
copied target will only show "NONE" on pin column, no matter what I do.
I had to manually edit every line of existing target to make it work.
if I copy existing column to a new column, it will only show "NONE".
@davidjacobs8558. Hi there. I have been away and have only just seen your video. It was a bit difficult to see what was happening. I added your target to the spreadsheet and it seemed to work fine. Please open the current file from the link and save a copy and the speedybeeF405V4 will be in the list.