2005 Acura TL Input/Output Shaft Speed Sensor Replacement

Поділитися
Вставка
  • Опубліковано 16 лют 2024
  • Hope this helped someone.
    #mechanic #carguys #honda #acura #diy
    Make sure y'all watch the full video❗️🔥
    My Social Media Links👇🏾
    / spazzkas
    / spazzkas
    vm.tiktok.com/TTPdjtsd9A/
  • Розваги

КОМЕНТАРІ • 8

  • @jeraldbennett8387
    @jeraldbennett8387 15 днів тому

    Question for a bad out put shaft speed sensor would cause an acura tl to rev. Up but will not move or move real slow. because that's what came up on my diagnostic tester.

    • @spazzkas
      @spazzkas  15 днів тому

      @@jeraldbennett8387 if it happens after only a few minutes of driving then the transmission is smoked. Very common problem on these.

  • @nathanramesar8007
    @nathanramesar8007 4 місяці тому +1

    2005 Acura rl, same problem but do I need to gap the sensor if so on the tip of the sensor or on the bolt where I tighten?

    • @spazzkas
      @spazzkas  4 місяці тому

      Nah, it should just fit in snug then just tighten it down like normal

  • @2012takvas
    @2012takvas 5 місяців тому +1

    What code were you getting. I'm getting 13-1 left wheel speed sensor open or shorted.

    • @spazzkas
      @spazzkas  5 місяців тому +1

      I don't too much remember the code, I already sold the car

  • @frias2287
    @frias2287 5 місяців тому +2

    💪💪🤝

    • @spazzkas
      @spazzkas  5 місяців тому

      😈💪🏾